Device driver installation

Device driver installation

Installing the device driver in Windows 95 or Windows 98

ENGLISH

This section must be completed before continuing with the Windows 95 or Windows 98 Image setup on page 14.

i On LCD monitors, unlike CRTs, a faster refresh rate

does not improve display quality. For optimal performance, use either 1280 x 1024 at a refresh rate of 60Hz or 640 x 480 at a refresh rate of 60Hz.

To install the device driver in Microsoft® Windows® 95 or Windows 98, do the following:

Note:

You must download files from the User’s Guide and Installation Files CD to use the Plug and Play feature in Windows 95 or Windows 98.

1.Turn off the computer and all attached devices.

2.Ensure that the monitor is connected correctly.

3.Turn on the monitor and then the system unit. Allow your computer to start the Windows 95 or Windows 98 operating system.

Your computer’s Plug and Play code might warn you that your system hardware has changed. This means that it has detected your new monitor for the first time.

4.Open the Display Properties window by clicking Start -> Settings -> Control Panel and then double-clicking on the Display icon.

5.Click the Settings tab.

6.If you are using Windows 95, complete the following steps:

a.Click the Change Display Type button.

b.Click the Change Monitor Type button.

c.Proceed to Step 7.

If you are using Windows 98, complete the following steps: a. Click the Advanced button.

b. Click the Monitor tab.

c. Open the Update Device Driver Wizard window by clicking on the Change button and then select the Next button.

d. Select Display a list of the known drivers for this device so that I can choose a specific driver and then select the Next button.

e. Proceed to Step 7.

7. Insert the User’s Guide and Installation Files CD into the CD drive and click the Have Disk button.

8. Click OK.

9. Ensure that the CD drive letter is selected, and then select the DRIVERS folder.

10. Select IBM L190 monitor and click OK. The files will be copied from the CD to your hard disk drive.

11. Close all open windows and remove the CD.

12. Restart the computer.

The system will automatically select the maximum refresh rate and

corresponding Color Matching Profiles.