Manual Image setup

ENGLISH

i If the monitor is in standby mode, it might automatically

turn off while you are waiting for it to warm up.

Normally, you can complete the setup procedure using Automatic Image setup; however, if your screen image is still distorted after you perform Image setup or the setup CD does not run on your system, perform Manual Image setup.

To manually adjust the image setting, do the following:

1.Turn on the monitor and wait approximately 15 minutes for it to warm up.

2.Display the image you most frequently use on the screen.

3.Press the OSD Enter button " " at the bottom of the monitor to display the initial OSD menu.

4.Use the Right Arrow button " " to select the Image setup icon " " and press the OSD Enter button " " to access the function.

5.Use the Right Arrow button " ", to select manual. Press the OK button " " twice to select clock.

6.Use the Arrow buttons to manually adjust to correct for jitter or noise in the image. Press the OK button " ".

7.Press OK " " and use the Arrow buttons to adjust phase, then press OK " ".

Press OK " " again to save and exit. Then press Exit button " " twice to exit OSD.

You have completed the monitor setup.