Before Connecting

Chapter 2

Using BIPAC-2AB 2.0

Make sure that you have all you need to connect the BIPAC-2AB 2.0 ISDN a/b adaptor. You should have the following:

1.At least one analog telephone (or other analog device)

2.A power outlet that supplies 220 ~ 240 volts AC

3.An ISDN basic rate S0 interface released by PTT (Post, Telephone and Telegraph administration)

Connecting the BIPAC-2AB 2.0

Please refer to the following instructions and figures for installation procedures:

1.Connect one or two analog telephones (or other analog devices) to the RJ-11 jacks labeled “a/b 1” or “a/b 2” on the back of the BIPAC-2AB 2.0. Refer to Figure 2.

2.Connect your ISDN line to the RJ-45 jack labeled “ISDN S0” on the back of the BIPAC-2AB 2.0. Refer to Figure 2.

3.Plug the power adaptor into the power outlet. The POWER LED will illuminate on the front panel.