Troubleshooting and tips
The printer does not print
►Make sure that the printer is switched on and is
►Check that the cable connecting the notebook and the printer is connected properly.
►Check whether the correct printer driver is loaded (see printer documentation).
Acoustic warnings
A beep sounds every few seconds.
The battery is almost flat.
►Charge the battery.
Error messages on the screen
This section describes the error messages generated by the BIOS Setup Utility. Error messages displayed by the operating system or programmes are described in the relevant documentation.
CMOS Battery Bad
If the error message occurs repeatedly, the buffer battery in the notebook is flat. Contact your sales outlet or our hotline/help desk.
System CMOS checksum bad - Default configuration used
The system configuration information is incorrect.
►Switch the notebook off.
►Switch the notebook on.
►Enter the BIOS Setup Utility by pressing F2 .
►Select the entry Load Setup Defaults.
►Mark OK.
►Press the Enter key.
If the error message appears repeatedly, please contact the place of purchase or our hotline/help desk.
Extended memory failed at offset: xxxx Failing Bits: zzzz zzzz
When testing the extended memory an error has resulted at the address xxxx.
►Check whether the additional memory module has been inserted correctly.
If the error message appears repeatedly, please contact the place of purchase or our hotline/help desk.
18 |