Initial Setup
Initial Setup
You need this equipment:
•PC
•
Step 1 Obtain this information from your network administrator before you start the setup program:
•Switch IP address
•Subnet mask (IP netmask)
•Default gateway (router)
•Enable secret password
•Enable password
•Telnet password
Step 2 Connect the adapter cable to the console connector on the switch front panel. Connect the other end of the cable to the Ethernet port on your
You must supply the console cable if you did not order one with your switch.
333305
Step 3 | Start a | ||
Step 4 |
|
|
|
Configure the baud rate and character format of the PC or | • | 9600 baud | |
| terminal to match these console port default characteristics. | • | 8 data bits |
|
| ||
|
| • | 1 stop bit |
|
| • | No parity |
|
| • | None (flow control) |
Step 5 |
|
|
|
Power the switch. |
|
|
AC power switches: Plug the AC power cord into the switch power supply and into a grounded AC outlet. Set the power supply switch to ON.
DC power switches: See the wiring instructions in the hardware installation guide on Cisco.com.
Cisco ME
| 3 |
| |
|
|