Warning
Warning
Warning
To prevent bodily injury when mounting or servicing this unit in a rack, you must take special precautions to ensure that the system remains stable. The following guidelines are provided to ensure your safety:
•This unit should be mounted at the bottom of the rack if it is the only unit in the rack.
•When mounting this unit in a partially filled rack, load the rack from the bottom to the top with the heaviest component at the bottom of the rack.
•If the rack is provided with stabilizing devices, install the stabilizers before mounting or servicing the unit in the rack. Statement 1006
A readily accessible
This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the absence of a suitably installed ground conductor. Contact the appropriate electrical inspection authority or an electrician if you are uncertain that suitable grounding is available. Statement 1024
This warning applies to only the Cisco ME
Warning | Only trained and qualified personnel should be allowed to install, replace, or service this equipment. | |
|
| Statement 1030 |
|
|
|
|
|
|
Warning | This product requires | |
|
| Install only in accordance with national and local wiring regulations. Statement 1045 |
|
| |
|
|
|
Warning | To prevent the system from overheating, do not operate it in an area that exceeds the maximum recommended | |
|
| ambient temperature of: 122°F (50°C) Statement 1047 |
|
| |
|
|
|
Warning | Installation of the equipment must comply with local and national electrical codes. Statement 1074 | |
|
|
|
3Initial Setup
When you set up the switch to enter the initial IP information, the switch can then connect to local routers and the Internet. For further configuration, access the switch CLI.
Your switch might look different from the illustrations, but the instructions apply to all the Cisco ME switches. Some instructions depend on whether the switch uses AC or DC power.
5