Cisco Systems DS71-MD4 Port Device Name, Port Select Code, RTS/DTR Line Driver Inactivity State

DS71-MD4 Serial host and 56k Modem

Output Flow Control (Xmit) - Xon/Xoff is ( Off )

Stop/Restart Output Upon Receiving of Xoff/Xon ? (Y/N) :

Input Flow Control (Recv) - Xon/Xoff is ( Off )

Xoff/Xon sent based on Buffer - Full/Empty condition ? (Y/N) :

RTS/DTR Line Driver Inactivity State

RTS (Request to Send)/ DTR (Data Terminal Ready) is normally used in conjunction with an external modem. With no modem the RTS and DTS default state is High.

Select “RTS Driver State” the DS displays the following:

RTS Line Driver Inactive State is: High

High ? (Y/N, CR for no change):

Select “DTR Driver State” the DS displays the following:

DTR Line Driver Inactive State is: High

High ? (Y/N, CR for no change):

Port Device Name

Select a port and type the new name:

Enter New Port	Name (Max. 16	characters):
or press ENTER	for no change	................:

Port Select Code

The Port Select Code is an ASCII character string sent by the host terminal to the module to select an I/O port on a DS74 peripheral module. The Port Select Code’s factory default setting is $BT and is programmable up to 8 characters as shown.

Port Select Code :$BT

Change It ? (Y/N) :

Attention Character

Pressing the Attention Character 5 consecutive times will access the network main menu. The Default is a semi-colon (;). Select this option to change the attention character. The DS displays the following:

Attention Character :;

Change It ? (Y/N) :

NOTE: If you change the attention character and forget which letter or symbol you selected, the attention character will not echo if you are typing the correct character. You can type each character/symbol on the keyboard to find it, or reset the module to factory default to get the semi-colon back.

18