Implementing NTP on Cisco IOS XR Software
How to Implement NTP on Cisco IOS XR Software
Configuring the Source IP Address for NTP Packets
This task explains how configure the source IP address for NTP packets.
When the system sends an NTP packet, the source IP address is normally set to the address of the interface through which the NTP packet is sent.
Note No specific command enables NTP; the first NTP configuration command that you issue enables NTP.
SUMMARY STEPS
1.configure
2.ntp
3.source
4.end or commit
DETAILED STEPS
| Command or Action | Purpose |
Step 1 |
|
|
configure | Enters global configuration mode. | |
| Example: |
|
| RP/0/RP0/CPU0:router# configure |
|
Step 2 |
|
|
ntp | Enters NTP configuration mode. | |
| Example: |
|
| RP/0/RP0/CPU0:router(config)# ntp |
|
|
|
|
Cisco IOS XR System Management Configuration Guide