Cisco Systems OL-6380-01 manual Chassis Management-Configure Snmp Trap Client Window

Page 11

Chapter 5 Network Element Management

Network Element Management Window

layer2Only—SNMP trap client is defined on the datalink layer only.

layer3Only—SNMP trap client is defined on the network layer only.

layer2And3—SNMP trap client is defined on the datalink and network layers.

The IP address of the Cisco EMF server host should be in this list at all times. If it is not, then Cisco EMF will not receive any traps from the switch or router, which might result in an event being reported in an untimely fashion or an event being missed.

Configure—Launches the Chassis Management - Configure SNMP Trap Client window for modifying the Trap Client list.

Figure 5-3 Chassis Management—Configure SNMP Trap Client Window

 

 

Cisco Catalyst Switch Manager User Guide

 

 

 

 

 

 

OL-6380-01

 

 

5-11

 

 

 

Image 11
Contents Network Element Management Chassis Layer2/Layer3 Management Window Layer 3 Configuration Layer 2 ConfigurationCSM/7600 Manager NE Config/Mgmt ISystem Configuration TabIOS Session IP AddressOperating System Cat OS Session Reset SystemActions System Information TabCat OS Snmp Snmp Access TabSnmp Trap Snmp Trap TabTrap Generation Chassis Management-Configure Snmp Trap Client Window Additional Notes Tab Device Management TabMAC Address Query Window MAC Address Query Window Network ElementMAC Address Query OL-6380-01