Cisco Systems OL-9392-04 manual Port 10/100BASE-T Ethernet Switching Module WS-X6248-TEL

Chapter 2 Ethernet and Gigabit Ethernet Switching Modules

10/100 and 10/100/1000 Ethernet Switching Modules

48-Port 10/100BASE-T Ethernet Switching Module (WS-X6248-RJ45)

The 48-port 10/100BASE-T Ethernet switching module (WS-X6248-RJ45) provides 48 switched 10/100-Mbps autosensing, full or half-duplex ports. (See Figure 2-7.) The 48 ports have RJ-45 connectors for Category 3, Category 5, Category 5e, or Category 6 UTP or FTP cable.

The QoS port architecture (Rx/Tx) for this module is 1q4t/2q2t.

Figure 2-7 48-Port 10/100BASE-TX Ethernet Switching Module (WS-X6248-RJ45)

WS-X6248-RJ-45

1 2 12 14 24 26 36 38 48

												48 PORT													ETHERNET SWITCHING
1	2	3	4	5	6	7	8	9	10	11	12	10/100 BASE-T	13	14	15	16	17	18	19	20	21	22	23	24	MODULE	25	26	27	28	29	30	31	32	33	34	35	36	37	38	39	40	41	42	43	44	45	46	47	48

The front panel LEDs are described in Table 2-3 on page 2-21.

16791

48-Port 10/100BASE-T Ethernet Switching Module (WS-X6248-TEL)

The 48-port 10/100BASE-T Ethernet switching module (WS-X6248-TEL) provides 48 switched 10/100-Mbps autosensing, full or half-duplex ports. (See Figure 2-8.) Four RJ-21 connectors (12 ports per connector) use Category 3, Category 5, Category 5e, or Category 6 UTP or FTP cable to connect to the network.

The QoS port architecture (Rx/Tx) for this module is 1q4t/2q2t.

Figure 2-8 48-Port 10/100BASE-T Ethernet Switching Module (WS-X6248-TEL)

WS-X6248-RJ-TEL

-12												-24													-36													-48
1												13													25													37
												48 PORT													ETHERNET SWITCHING
1	2	3	4	5	6	7	8	9	10	11	12	10/100 BASE-T	13	14	15	16	17	18	19	20	21	22	23	24	MODULE	25	26	27	28	29	30	31	32	33	34	35	36	37	38	39	40	41	42	43	44	45	46	47	48

The front panel LEDs are described in Table 2-3 on page 2-21.

18502

48-Port 10/100BASE-T Ethernet Switching Module (WS-X6248A-TEL)

The 48-port 10/100BASE-T Ethernet switching module (WS-X6248A-TEL) provides 48 switched 10/100-Mbps autosensing, full or half-duplex ports. (See Figure 2-9.) The WS-X6248A-TEL Ethernet module has a larger buffer than the WS-X6248-TEL Ethernet module. Four RJ-21 connectors (12 ports per connector) use Category 3, Category 5, Category 5e, or Category 6 UTP or FTP cable to connect to the network.

The QoS port architecture (Rx/Tx) for this module is 1q4t/2q2t.

Figure 2-9 48-Port 10/100BASE-T Ethernet Switching Module (WS-X6248A-TEL)

WS-X6248-RJ-TEL

-12												-24													-36													-48
1												13													25													37
												48 PORT													ETHERNET SWITCHING
1	2	3	4	5	6	7	8	9	10	11	12	10/100 BASE-T	13	14	15	16	17	18	19	20	21	22	23	24	MODULE	25	26	27	28	29	30	31	32	33	34	35	36	37	38	39	40	41	42	43	44	45	46	47	48

The front panel LEDs are described in Table 2-3 on page 2-21.

Cisco 7600 Series Routers Module Guide

OL-9392-04

18502

2-7