What’s New in 4.1
GUI Instructions
Note When flashing the SCA, use the file
1.Open a Web browser and connect to the Secure Content Accelerator.
2.Ensure that the General>Status page is displayed.
3.Click Tools to activate the Tools tabs.
4.Click the Firmware tab.
5.Type the path and firmware image file name or URL in the Upload Firmware text box, or click Browse and navigate to and select the firmware image file from the local file system.
6.Click Upload to load the firmware image into the GUI.
7.Click Install Image next to the file information in the Installable Firmware Images panel.
8.After the new firmware has uploaded, click the Restart tab.
9.Click Reboot to reload the device. Wait several minutes for the device to reboot.
10.Reconnect to the device using the GUI and the IP address assigned to it.
11.Click General to activate the General tabs.
12.The Release panel should contain “4.1”.
13.Continue with configuration as desired.
What’s New in 4.1
•Configuration is no longer allowed from the remote configuration manager.
•Some TCP parameters can be configured using the TCP Tuning Configuration mode.
•A hybrid transparent mode (transparent
Operational Notes
•To negotiate a connection with FIPS
•The commands erase
•The 4.x and previous versions of Netscape can “hang” when client authentication fails. If this happens, the server must be rebooted.
•If using IIS authentication, the basic form of Secure URL Rewrite cannot be used. The redirectonly option should be used.
•Configuring a device using multiple sessions or methods simultaneously can cause undesirable results. We recommend only one session be used at a time to make configuration changes.
•After changing a device from
Release Note for the Cisco 11000 Series Secure Content Accelerator: SCA/SCA2
| 3 |
| |
|
|