Cisco Systems OC192/STM64 LR/LH 4 technical specifications Replace an OC-192 Card

Replace an OC-192 Card

OC1928/STM64 LR/LH 4 Port 1550 Card OGI Connector Pinout

Table 5 shows the OC192/STM64 LR/LH card OGI connector pinouts.

Table 5	OC192/STM64 LR/LH 4 Port 1550 Card OGI Connector Pinout
Connector		OGI Pin and Card Port
1		1		2	3	4	5		6		7		8
		—	—		Transmit 1	Receive 1	—	—		—		—
2		1		2	3	4	5		6		7		8
		—	—		Transmit 2	Receive 2	—	—		—		—
3		1		2	3	4	5		6		7		8
		—	—		Transmit 3	Receive 3	—	—		—		—
4		1		2	3	4	5		6		7		8
		—	—		Transmit 4	Receive 4	—	—		—		—

Replace an OC-192 Card

Purpose	This procedure is used to replace a faulty OC-192 card.
Tools/Equipment	Replacement OC-192 card
Prerequisite Procedures	None
Required/As Needed	As needed
Onsite/Remote	Onsite

Warning Do not reach into a vacant slot or chassis while you install or remove a module or a fan. Exposed circuitry could constitute an energy hazard.

Note Card removal raises an improper removal (IMPROPRMVL) alarm, but this clears after the card replacement is completed.

Step 1 Log into the node where you will replace the OC-192 card. If necessary, refer to the

Cisco ONS 15600 Procedure Guide for a login procedure.

Step 2 Ensure that the card you are replacing does not carry traffic in a 1+1 group:

a.In the node view, click the Maintenance > Protection tabs.

b.Choose the first group listed under Protection Groups.

c.Verify that the slot number for the card you are replacing does not appear in the Selected Groups list. For example, if you are replacing the OC-192 card in slot 3, make sure that Selected Groups does not contain any entries that start with s3, regardless of the port.

d.Repeat Steps b and c for each protection group.

e.If any of the groups contain a port on the card you want to replace, perform the “Force-Switch 1+1 Ports” task on page 10 .

Installing the Cisco ONS 15600 OC192/STM64 LR/LH 4 Port 1550 Card

8 78-15181-01