Cisco Systems OL-11567-02 manual Fips, Voice Wlan Configuration, Inter-Subnet Roaming

Important Notes

Step 3 To create a new SNMP v3 user, enter this command:

config snmp v3user create username {ro rw} {none hmacmd5 hmacsha} {none des} auth_password privacy_password

where

•username is the SNMP v3 username,

•ro is read-only mode and rw is read/write mode,

•none, hmacmd5, and hmacsha are the authentication protocol options,

•none and des are the privacy protocol options,

•auth_password is the authentication password, and

•privacy_password is the privacy password.

Do not enter “default” for the username and password parameters.

Step 4 To save your changes, enter save config.

FIPS 140-2

The Cisco 4400 Series Controllers are on the NIST FIPS 140-2 Pre-Validation List.

Controllers Must Run Release 3.2.116.21 or Later to Support -P Regulatory Domain

To support access points configured for use in Japan, you must upgrade the controller software to release 3.2.116.21 or later. Earlier releases do not support access points configured for use in Japan (regulatory domain -P).

Voice WLAN Configuration

Cisco recommends that load balancing always be turned off in any wireless LAN that is supporting voice, regardless of vendor. When load balancing is turned on, voice clients can hear an audible artifact when roaming, and the handset is refused at its first reassociation attempt.

Inter-Subnet Roaming

Currently, multicast traffic cannot be passed during inter-subnet roaming.

Operating Mesh Networks Through Switches and Routers

In mesh networks that operate through low-speed switches and routers, access points can disconnect from the controller, causing the controller to generate alerts.

Release Notes for Cisco Wireless LAN Controllers and Lightweight Access Points for Release 3.2.171.6

OL-11567-02 9