Chapter 2 Setting Up Your Cisco Unified Videoconferencing 3515 MCU
Cisco Unified Videoconferencing 3515 MCU Unit Initial Configuration
Setting the IP Address
This section describes how to use the serial port to configure the unit with an IP address and other address information.
The upper serial port on the Cisco Unified Videoconferencing 3515 MCU unit front panel is used to assign a new IP address to your Cisco Unified Videoconferencing 3515 MCU unit. You can assign the IP address before or after you connect the hardware to the network.
Before You Begin
Gather the items listed in Table
Videoconferencing 3515 MCU unit.
Table
Requirements | Notes |
Dedicated IP address for the Cisco Unified
Videoconferencing 3515 MCU unit
IP address of the default router the Cisco Unified Videoconferencing 3515 MCU unit uses to communicate over the network
Subnet mask for the Cisco Unified
Videoconferencing 3515 MCU unit if applicable
Domain Name Server and domain name for Cisco Unified Videoconferencing 3515 MCU unit if applicable
PC with available serial port and terminal emulator software installed
Procedure
Step 1 Connect the
Step 2 Connect the power cable.
Step 3 Start the terminal emulation application on the PC.
Step 4 Set the communication settings in the terminal emulation application on the PC as follows:
–Baud rate: 9600
–Data bits: 8
–Parity: None
–Stop bits: 1
–Flow control: None
Step 5 Turn on the power to the Cisco Unified Videoconferencing 3515 MCU unit.
A log of the
Step 6 When the message “Press any key to start configuration” appears on the screen, press any key within six seconds.
Installation and Upgrade Guide for Cisco Unified Videoconferencing 3515 MCU12 and MCU24 Release 5.1
|
| |
|