Removing and Replacing a SCSI Hard Disk Drive
Step 3 Power down the device and peripheral devices, and disconnect the power cord and all external cables. Step 4 Press the release tabs on the bezel, and pull the bezel away from the chassis. (See Figure 1.)
Step 5 Remove the chassis cover. (See Figure 2.)
Step 6 To remove the hard disk drive in either drive bay, work from inside the chassis and disconnect the SCSI cable from the hard disk drive by using your thumbs to work the cable connector out of the drive connector. Do not pull directly on the cable itself.
Tip To remove the hard disk drive in the first bay (the bay on the left below the
Step 7 Disconnect the power cable from the hard disk drive.
Step 8 Gently pull the carrier handle (labeled 6 in Figure 5), and slide the hard disk drive out of the drive bay.
Step 9 Before you install the new drive in a drive bay, check the jumper pins to make sure that you have the correct SCSI ID set on the drive, as follows:
•SCSI ID 0 for drive bay 0
•SCSI ID 1 for drive bay 1
Step 10 Slide the new disk drive back into the drive bay with the circuit board on the drive facing up. (See Figure 3.)
Figure 5 shows the disk drive connector and pin locations and the orientation of the disk drives for installation. (See also Figure 3.)
Figure 5 | Disk Drive Orientation During Installation |
1
2
3
4
65
151557
Installing Hard Disk Drives in the Cisco Wide Area Application Engine 611
8 |
| |
|