Handling a Processor Module | Cisco Systems Cisco 7505, Cisco 7010

Replacing the Chassis

Step 9 Using the thumb and foreﬁnger of each hand to pinch each ejector, simultaneously push both ejectors inward (toward the carrier handle) until they snap into place and are at a full 90-degree orientation to the faceplate. (See Figure 8c.) The carrier ears (the ends of the faceplate) should be ﬂush against the chassis.

Step 10 Use a screwdriver to tighten the two captive screws to prevent the processor module from becoming partially dislodged from the backplane and to ensure proper EMI shielding.

Step 11 Repeat Steps 2 through 10 for the remaining interface processors.

Step 12 Repeat Steps 3 through 10 for the SP (or SSP) and RP in the Cisco 7010, and the RSP1 in the Cisco 7505.

Figure 9 Handling a Processor Module

H1985

Captive installation screws

Note Leave the interface processor ﬁller installed in any unﬁlled interface processor slots.

This completes the processor module removal and replacement procedure. If you now need to install the new chassis in an equipment rack, proceed to the section “Installing the New Chassis in the Rack” on page 10. Otherwise, proceed to the next section to check the installation.

Cisco 7010 and Cisco 7505 Chassis Replacement Instructions 17