Cisco Systems 545 Serial manual Installing the Cisco Unified Videoconferencing 3545 Gateway

C H A P T E R 2

Installing the Cisco Unified

Videoconferencing 3545 Gateway

This section describes the following topics:

•Physical Description, page 2-1

•Preparing for Installation, page 2-3

•Verifying the Package Contents, page 2-4

•Mounting the Cisco Unified Videoconferencing 3545 Chassis in a 19-inch Rack, page 2-5

•Installing the Gateway, page 2-6

•Initial Gateway Configuration, page 2-10

•Connecting the Gateway to the Network, page 2-14

•Connecting PRI Lines to the Gateway, page 2-14

•Connecting Serial Lines to the Gateway, page 2-14

•Serial Gateway Cable Connections and Pin-outs, page 2-15

•Connecting the Gateway to a Power Source, page 2-27

•Accessing the Gateway Administrator Interface, page 2-27

•Registering the Online Help, page 2-28

Physical Description

This section provides a physical description of the gateway modules and their corresponding RTMs.

Gateway Module

The gateway module has a 10/100BaseT Ethernet port on the front panel that uses an RJ-45 connector to connect to the network. There is an asynchronous, 9-pin serial port that you can use with a hyperterminal program to configure and monitor the module.

Figure 2-1shows the front panel components of the gateway module. Table 2-1describes these components.

Installation and Upgrade Guide for Cisco Unified Videoconferencing 3545 PRI Gateway and 3545 Serial Gateway Release 5.5

OL-14912-01 2-1