Cisco Systems 2600, AIRSAP2602IAK9, AIRSAP2602EAK9 Troubleshooting the Access Point Join Process

Table 1	LED Status Indications (continued)
Message		Status	Message
Type		LED	Meaning
Operating status		Blinking blue	Software upgrade in progress
		Cycling through green,	Discovery/join process in progress
		red, and off
		Rapidly cycling	Access point location command invoked
		through blue, green,
		and red
		Blinking red	Ethernet link not operational
Boot loader warnings		Blinking blue	Configuration recovery in progress (MODE
			button pushed for 2 to 3 seconds)
		Red	Ethernet failure or image recovery (MODE
			button pushed for 20 to 30 seconds)
		Blinking green	Image recovery in progress (MODE button
			released)
Boot loader errors		Red	DRAM memory test failure
		Blinking red and blue	FLASH file system failure
		Blinking red and off	Environment variable failure
			Bad MAC address
			Ethernet failure during image recovery
			Boot environment failure
			No Cisco image file
			Boot failure
Cisco IOS errors		Red	Software failure; try disconnecting and
			reconnecting unit power
		Cycling through blue,	General warning; insufficient inline power
		green, red, and off

Troubleshooting the Access Point Join Process

Access points can fail to join a controller for many reasons: a RADIUS authorization is pending; self-signed certificates are not enabled on the controller; the access point’s and controller’s regulatory domains don’t match, and so on.

18