Cisco Systems 2600 Access Point Specifications, Add the option 60 line using the following syntax

<Default router> is the IP address of the default router, such as 10.0.0.1 <DNS Server> is the IP address of the DNS server, such as 10.0.10.2

Step 3 Add the option 60 line using the following syntax:

option 60 ascii “VCI string”

For the VCI string, “Cisco AP c2600”, the quotation marks must be included.

Step 4 Add the option 43 line using the following syntax:

option 43 hex <hex string>

The hex string is assembled by concatenating the TLV values shown below:

Type + Length + Value

Type is always f1(hex). Length is the number of controller management IP addresses times 4 in hex. Value is the IP address of the controller listed sequentially in hex.

For example, suppose that there are two controllers with management interface IP addresses, 10.126.126.2 and 10.127.127.2. The type is f1(hex). The length is 2 * 4 = 8 = 08 (hex). The IP addresses translate to 0a7e7e02 and 0a7f7f02. Assembling the string then yields f1080a7e7e020a7f7f02. The resulting Cisco IOS command added to the DHCP scope is option 43 hex f1080a7e7e020a7f7f02.

13Access Point Specifications

Table 2 lists the technical specifications for 2600 series access points.

Table 2	Access Point Specifications
Category		Specification
Dimensions (LxWxD)		8.68 x 8.68 x 1.84 in. (22.04 x 22.04 x 4.67 cm)
Weight		AP2602E: 2.7 lbs (1.22 kg)
		AP2602I: 2.3 lbs (1.04 kg)
Operating temperatures		AP2602E: -4 to 131 degrees F (-20 to 55 degrees C)
		AP2602I: 32 to 104 degrees F (0 to 40 degrees C)
Storage temperature		–22 to 185 degrees F (–30 to 85 degrees C)
Humidity		10% to 90% (noncondensing)
Antennas		AP260xI: Integrated; AP260xE: External
36