Cisco Systems AS5400 manual Online Insertion and Removal OIR of DFCs

Page 20

Chapter 2 Dial Feature Card and Carrier Card Guidelines

Online Insertion and Removal (OIR) of DFCs

•Universal access (analog modem or digital calls) is supported when an interface is configured for ISDN PRI signaling. PRI signaling is available for both T1 and E1 trunks.

In any single DFC slot, you can install your choice of:

•One T1, E1, or T3 dial feature card

•One universal port card

Online Insertion and Removal (OIR) of DFCs

All DFCs on the Cisco AS5350 and Cisco AS5400 chassis support online insertion and removal (also known as hot swapping). You can install, remove, replace, and rearrange the DFCs without turning off the chassis power.

When the chassis detects that a DFC is installed or removed, it automatically runs diagnostic and discovery routines, acknowledges the presence or absence of the DFC, and resumes chassis operation without any operator intervention.

See:

•Chapter 3, “T1 and E1 Dial Feature Cards,” to perform OIR of the T1 or E1 DFC.

•Chapter 4, “T3 Dial Feature Card,” to perform OIR of the T3 DFC.

•Chapter 5, “Universal Port Dial Feature Card,” to perform OIR of the universal port DFC.

Removing and Installing Populated Carrier Cards

Caution The carrier cards that carry the DFCs are not hot swappable. Removing a card while the system is still powered on may cause permanent damage to electronic circuits on the card.

The DFC carrier card plugs into one of the backplane slots and supports two DFCs. The carrier card increases backplane capacity and allows OIR of the DFCs. (See Figure 2-1.)

Figure 2-1 Carrier Card With Two 8 PRI CT1 Cards

29032

Warning Before working on a chassis or working near power supplies, unplug the power cord on AC units; disconnect the power at the circuit breaker on DC units. To see translations of the warnings that appear in this publication, refer to the Regulatory Compliance and Safety Information document that accompanied this device.

Cisco AS5350 and Cisco AS5400 Universal Gateway Card Installation Guide

2-2

78-13311-01

 

 

Page 19 Page 21
Image 20
Page 19 Page 21
Contents Corporate Headquarters Customer Order Number DOC-7813311= Text Part NumberCisco AS5350 and Cisco AS5400 Universal Gateway Card Getting Help Verification Getting Help Cabling Specifications Getting HelpPage Document Organization Chapter Title DescriptionDocument Conventions Convention DescriptionPreface Document Conventions Preface Document Conventions Obtaining Documentation World Wide WebDocumentation CD-ROM Ordering DocumentationTechnical Assistance Center Obtaining Technical AssistanceCisco.com New Hardware Features Related DocumentationXiv Safety Warnings, Recommendations, and Tools Required General SafetyMaintaining Safety with Electricity Preventing Electrostatic Discharge Required Tools and EquipmentWhere to Go Next Dial Feature Card and Carrier Card Guidelines Dial Feature CardsOverview Cisco AS5350 ChassisRemoving and Installing Populated Carrier Cards Online Insertion and Removal OIR of DFCsRemoving a Populated Carrier Card Loosen the Captive Screws on the Cisco AS5350Loosen the Captive Screws on the Cisco AS5400 Installing a Populated Carrier Card Blank Filler PanelTighten the Captive Screws on the Cisco AS5350 Getting Help Page T1 and E1 Dial Feature Cards Description Specification 4-Port T1 or E1 DFCRemoving the T1 or E1 DFC Online Installation and Removal of the T1 or E1 DFCOverview Router# busyout slot-number Screw Carrier Card Remove the DFC from the Cisco AS5350 Router# show controller e1 6/0 timeslot Show chassis slot Installing the T1 or E1 DFC 11 Install the T1 or E1 DFC in the Cisco AS535012 Install the T1 or E1 DFC in the Cisco AS5400 Configuring Input Impedance for the E1 DFC ConfigurationCommand Purpose VerificationHostname Router No ip mroute-cache T1 and E1 Dial Feature Cards Getting Help T3 Dial Feature Card Online Installation and Removal OIR of the T3 DFC Removing the T3 DFCRouter# busyout slot-number 58760 Installing the T3 DFC Blank DFC CoverInstall the T3 DFC in the Cisco AS5350 12 Tighten the Captive Screws on the Cisco AS5400 Page Universal Port Dial Feature Card Online Insertion and Removal OIR of the Universal Port DFC Removing the Universal Port DFCRouter# busyout slot-number 36821 Show busyout Router# clear port Installing the Universal Port DFC Install the Universal Port DFC in the Cisco AS535036818 Troubleshooting Appendix A, Cabling Specifications SPE FirmwarePage Troubleshooting LEDsUniversal Port DFC LEDs DFC LED State DescriptionT3 DFC Activity ACT DFC OK/MAINT Mixing WAN DFCsEnvironment Monitoring Displaying Environment Status Router show environment Drop and Insert Mode for the CT3 DFC Using the Bantam Jacks for Test Port FunctionalityMonitoring Mode for the T1, E1 and T3 DFCs Troubleshooting Network Interfaces RJ-45 Pin Description T1 and E1 Cable and Port PinoutsPort and 4-Port T1 or E1 DFC RJ-45 Pin Signal Description Direction DB-15 Pin Figure A-1 RJ-45-to-DB-15 Cable AssemblyRJ-45 Pin Signal Description Direction RJ-45 TE Pin RJ-45 Pin Signal Description Direction BNC PinRJ-45 Pin Signal Description Direction Twinax Pin RJ-45 Pin Signal Description Direction RJ-45 NT Pin RJ-45 Pin Signal Description Direction RJ-45 T1 PinCable Description Part Number Product Number RJ-45 Pin Signal Description Direction BarePort T1 or E1 DFC Shell Ground SHELL/BRAID J1-21 Attaching the 8-Port Interface Cable to a Bracket Optional 35059 35060 Figure A-10 Securing the Cable Bracket to the Rack 35062 Pin Description CT3 Cable and Port PinoutsBantam Jack Port Pinouts Appendix a Cabling Specifications Bantam Jack Port Pinouts Numerics IN-2 IN-3 IN-4 IN-5 IN-6
Related manuals
Manual 88 pages 30.73 Kb Manual 6 pages 32.91 Kb

AS5400 specifications

Cisco Systems has long been a leader in the networking and telecommunications field, and its AS5800 series of routers exemplify this tradition. The AS5800, along with the AS5850, AS5350, AS5400, and AS5300, provides robust solutions for service providers and enterprise-level networking applications. Each of these models has distinct features and characteristics that cater to the evolving demands of internet traffic and data processing.

The Cisco AS5800 is designed for high-capacity routing and optimized for broadband services. It supports a wide range of services, including voice, data, and video applications, making it a versatile option for service providers looking to deliver integrated solutions. It is equipped with advanced quality of service (QoS) features that ensure bandwidth is allocated effectively, holding strong even under heavy traffic conditions.

In comparison, the AS5850 offers superior processing capabilities and is typically utilized in larger-scale implementations. This model supports high-density interfaces, allowing numerous connections without compromising performance. Its architecture includes enhanced MPLS (Multiprotocol Label Switching) support, enabling more efficient traffic management and better utilization of network resources.

The AS5350 is known for its scalability and energy efficiency, ideal for voice-over-IP (VoIP) and media gateway applications. It supports various telephony features, such as protocol interworking and transcoding, making it a preferred choice for organizations focusing on digital voice technologies. The AS5300, while slightly older, continues to be a valuable asset for less demanding networks, offering reliable performance with VoIP capabilities and basic data applications.

The AS5400 bridges the gap between high-performance routing and operational efficiency. It incorporates Cisco's proprietary technologies to ensure seamless connectivity and robust failover systems. This model is highly regarded for its security features, protecting network integrity and providing peace of mind for businesses relying on sensitive data transfer.

Overall, Cisco’s AS5800 series showcases a progressive evolution of routing capabilities with enhanced features tailored for resilience, scalability, and performance. These routers not only address the technical needs of modern networks but also strategically position organizations for future growth in an increasingly digital world. Each model, with its unique attributes, continues to support the varied demands of global communication infrastructures.
Top Page Image Contents