Cisco Systems 1010 manual Cabling and Configuring the CES Port Adapter Modules

Page 1

C H A P T E R

8

Cabling and Configuring the CES Port Adapter Modules

This chapter describes cabling and configuration procedures for the LightStream 1010 asynchronous transfer mode (ATM) switch circuit emulation service (CES) T1 and E1 port adapter modules (PAMs). When your switch leaves the factory, it is configured as specified in your order and is ready for installation and startup. As your communication requirements change, you might want to upgrade your system, add components, or change the initial configuration.

The following CES T1 and E1 PAMs are described in this chapter:

CES T1 Twisted-pair Port Adapter Module

CES E1 Twisted-pair Port Adapter Module

CES E1 BNC Port Adapter Module

Software and upgrades require specific document part numbers and other frequently updated information; therefore, only basic software configuration guidelines are included in this publication. Detailed, up-to-dateinstructions are included in the LightStream 1010 ATM Switch Software Configuration Guide and command line interface (CLI) command descriptions are provided in the LightStream 1010 ATM Switch Command Reference.

This chapter contains the following information:

Overview of the CES Port Adapter Modules

Connecting the Interface Cables and Checking the LEDs

Configuring the Interfaces

Cabling and Configuring the CES Port Adapter Modules 8-1

Image 1
Contents Cabling and Configuring the CES Port Adapter Modules FCC Part 68 Notice This equipment uses Usoc jacks as listed in Table Overview of the CES Port Adapter ModulesTypical CES T1 or E1 Port Adapter Module UTP Port Shown CES T1 and E1 PAM Applications CES T1 and E1 PAM FeaturesCES T1 and E1 Port Adapter Module Applications CES Connection Equipment Connecting the Interface Cables and Checking the LEDsCES T1 and E1 PAM Network Connections and LEDs CES T1 and E1 Module LEDs RJ-48c connectors Port Status Conditions Indicated by CES T1 or CES E1 LEDs Configuring the Interfaces Default ATM Interface Configuration Without AutoconfigurationCES T1 PAM
Related manuals
Manual 8 pages 55.56 Kb