Cisco Systems 1010 manual CES T1 and E1 Module LEDs

Page 8

Connecting the Interface Cables and Checking the LEDs

The CES PAM can support interfaces that connect to the following physical layers:

•

•

E1 G.703 with HDB3 coding

E1 2.048 Mbps coaxial cable

Connect the CES interface cables as shown in Figure 8-3. For detailed descriptions of ATM cabling requirements, refer to the sections “Distance Limitations” and “ATM Connection Equipment” in the chapter “Preparing for Installation.”

CES T1 and E1 Module LEDs

This section describes the LEDs on the faceplate of the CES modules, shows their possible illumination states, and defines the operational status of the associated ports, given certain illumination patterns of the LEDs.

The LEDs provide status information for the port adapter module’s individual BNC and twisted-pair interface connections. The LEDs are shown in Figure 8-3.

8-8LightStream 1010 ATM Switch PAM Installation Guide

Page 7 Page 9
Image 8
Page 7 Page 9
Contents Cabling and Configuring the CES Port Adapter Modules FCC Part 68 Notice Overview of the CES Port Adapter Modules This equipment uses Usoc jacks as listed in TableTypical CES T1 or E1 Port Adapter Module UTP Port Shown CES T1 and E1 PAM Features CES T1 and E1 PAM ApplicationsCES T1 and E1 Port Adapter Module Applications CES T1 and E1 PAM Network Connections and LEDs Connecting the Interface Cables and Checking the LEDsCES Connection Equipment CES T1 and E1 Module LEDs RJ-48c connectors Port Status Conditions Indicated by CES T1 or CES E1 LEDs Default ATM Interface Configuration Without Autoconfiguration Configuring the InterfacesCES T1 PAM
Related manuals
Manual 8 pages 55.56 Kb
Top Page Image Contents