Cisco Systems Cisco 10000 ESR manual Contents

Page 1

Cisco 10000 ESR

AC Power Entry Module Installation

This publication contains instructions for installing the AC Power Entry Module (PEM) in the Cisco 10000 Edge Services Router (ESR). If you are not familiar with the Cisco 10000 router, see the Cisco 10000 ESR System Description, and the Cisco 10000 ESR Hardware Installation Guide for additional information.

Contents

The following sections are included in this configuration guide:

•Product Description, page 2

•Prerequisites and Preparation, page 3

•Installation Guidelines, page 4

•Adding or Replacing an AC PEM, page 5

•FCC Class A Compliance, page 20

•Cisco Connection Online, page 20

•Documentation CD-ROM, page 22

Corporate Headquarters: Cisco Systems, Inc., 170 West Tasman Drive, San Jose, CA 95134-1706 USA

Copyright © 2000. Cisco Systems, Inc. All rights reserved.

78-10832-01

Page 1 Page 2
Image 1
Page 1 Page 2
Contents Cisco 10000 ESR ContentsProduct Description Prerequisites and Preparation Safety GuidelinesRequired Tools and Equipment Installation GuidelinesRemoving the Front Cover Adding or Replacing an AC PEMContinue installing or replacing the AC PEM ESD Installing a Second AC PEMRemoving the Blank Cover Installing an AC PEM AC Power Cord Connectors in Canoes Replace the front cover Replacing an AC PEM Power off the PEM you are replacing Figure Loop Carrier Alarmlo AUX Ctiv ETH ITY SLO SL LI ERN Removing an AC PEM Installing an AC PEM AC Power Cord Connectors in Canoes Cisco 10000 ESR AC Power Entry Module Installation Symptom Description Troubleshooting the InstallationCisco Connection Online FCC Class a ComplianceCisco Connection Online Documentation CD-ROM
Top Page Image Contents