![](/images/new-backgrounds/1106495/10649581x1.webp)
Cisco Aironet Access Point Deployment Guide
The AP 2600, while similar to the AP 3600, is slightly different since it is a 3x4:3. This means that the AP 2600 also has four antennas to help on the receive (upstream signal) but uses only three transmitters on the downstream side.
The yellow sections of the MCS chart (see Figure 54) depict the faster data rates supported by the AP 3600. The AP 3600 supports 802.11a/b/g rates as well as 802.11n rates of MCS values 0‐23.
Figure 54: AP 2600/3600 Supports up to 450 Mbps (MCS Rates 0‐23); AP 1600 (MCS Rates 0‐15)
These additional MCS rates permit more choices for the client supporting 3SS when making rate‐shifting decisions, since the rate‐shifting algorithm maintains the best overall throughput connection.
Clients That Support Three Spatial Streams
Clients with 3SS support are now more common. As the new 802.11ac specification becomes more accepted, many newer client adapters will have the newer chipsets and support 3SS as a subset to 802.11ac. Unlike many competitors, the AP 1600/2600 and the AP 3600 fully support all the DFS channels for more usable channels in the 5 GHz range. More clients, especially 802.11ac clients, will start to emerge and support these newer channels in 802.11n modes.
Currently the most popular 3SS client is the Apple 2011 MacBook Pro. It is based upon the Broadcom BCM4331 chipset and a small USB adapter (TEW 684UB) by Trendnet, based on the Ralink chipset.
The Intel 5300 and 6300 has supported 3SS for a long time. Perhaps because this card is installed in different hardware platforms, testers have observed good throughput (+320 Mbps) on many notebooks and reduced throughput (such as 240 Mbps) on other notebooks. If you experience low throughput with the Intel card, try a MacBook Pro or Trendnet adapter. If they perform well, try another notebook with
Cisco Systems
Copyright © 2012 Cisco Systems, Inc. All rights reserved.
Page 41 of 52