Cisco Systems 71642 manual Create the Vocera Voice Interface, Wireless−Specific Configuration

Page 19

Figure 10List of WLC Interfaces

Create the Vocera Voice Interface

Complete these steps:

1.Click New.

2.Enter a tag name representative of your Vocera VoWLAN network in the Interface Name field.

3.Enter the VLAN number of that VoWLAN network in the VLAN ID field.

4.Click Apply and then click Edit in order to edit the interface that you just created.

5.Enter the IP addressing for this interface that is in the range of the VLAN and other related information.

6.Click Apply.

Wireless−Specific Configuration

For a WLAN that has only Vocera Badges, this configuration provides sample settings that best support the Vocera Broadcast application.

∙The DTIM Period is 1.

∙Support for 802.11g is disabled. Only the 802.11b data rate of 11 Mpbs is Mandatory.

∙Short preamble is disabled.

∙DTPC is disabled.

Figure 11802.11b/g Configuration

Image 19

Contents Deployment Scenarios Document IDRequirements Components Used IntroductionPrerequisites Executive SummaryVocera Communications Server Capacity Vocera SolutionVocera Badge Overview Vocera Call Capacity ConsiderationsArchitecture Overview Voceras Infrastructure PlanningUnicast−Multicast Delivery Method Multicast in an Lwapp DeploymentLwapp Multicast−Multicast Multicast−Multicast Delivery MethodEnable IP Multicast Routing Router and Switch Multicast ConfigurationEnable PIM on an Interface Deployment Scenarios Disable Switch Vlan Igmp SnoopingMulticast Enhancements in Version 4.0.206.0 and Later Single Controller Deployment Single Controller in Multicast−Multicast ModeMultiple Controller Layer 3 Deployment Multiple Controller Layer 2 DeploymentConstruction Methods and Materials VoWLAN Deployments Ciscos ReccommendationsInventory Leap Considerations Security Mechanisms SupportedVoice, Data and Vocera VLANs Wireless Network InfrastructureNetwork Sizing Deployments and Configuration Switch RecommendationsBadge Configuration Tune AutoRF for Your Environment ∙ How do I know if the tranmit power is too hot or too cold? Create Interfaces Wireless Network Infrastructure ConfigurationCreate the Vocera Voice Interface Wireless−Specific ConfigurationWlan Configuration Wlan ConfigurationAP Detail Configure Access Point DetailConfigure the 802.11b/g Radio Wireless IP Telephony Verification Association, Authentication, and Registration Badge Loses Voice Quality while Roaming Common Roaming IssuesChoppy or Robotic Audio Audio ProblemsRegistration and Authentication Problems One−sided AudioAppendix a AP and Antenna PlacementSignal Reflection Caused by a Wall Cisco Aironet 5959 Antenna Mounted to a Ceiling Interference and Multipath Distortion Signal−to−Noise Ratio SNRSignal Attenuation NetPro Discussion Forums − Featured ConversationsRelated Information