Cisco Systems 71642 manual Wireless Network Infrastructure Configuration, Create Interfaces

Page 18

Wireless Network Infrastructure Configuration

The Cisco Unified Wireless Network design and deployment guide should be followed for the overall configuration of your WLC(s). This section provides additional recommendations specific to Vocera® Communication Badges.

Note: Changes are left unsaved if you do not press the Apply button before you move to the next step.

Complete these steps under the Controller top−level menu:

1.Change Ethernet Multicast Mode to Multicast.

2.Set the Multicast Group Address to 239.0.0.255 (or some other unused multicast group address).

3.Set the Default Mobility Domain Name and RF−Network Name to your network design.

4.Disable Aggressive Load Balancing.

Figure 9General WLC Configuration

Create Interfaces

Click Controller > Interfaces.

Note: Your VLAN and IP address varies. The screen shots here provide sample addressing which should not be directly followed.

Image 18

Contents Document ID Deployment ScenariosExecutive Summary IntroductionPrerequisites Requirements Components UsedVocera Call Capacity Considerations Vocera SolutionVocera Badge Overview Vocera Communications Server CapacityVoceras Infrastructure Planning Architecture OverviewMulticast in an Lwapp Deployment Unicast−Multicast Delivery MethodMulticast−Multicast Delivery Method Lwapp Multicast−MulticastRouter and Switch Multicast Configuration Enable IP Multicast RoutingEnable PIM on an Interface Disable Switch Vlan Igmp Snooping Deployment ScenariosMulticast Enhancements in Version 4.0.206.0 and Later Single Controller in Multicast−Multicast Mode Single Controller DeploymentMultiple Controller Layer 2 Deployment Multiple Controller Layer 3 DeploymentVoWLAN Deployments Ciscos Reccommendations Construction Methods and MaterialsInventory Security Mechanisms Supported Leap ConsiderationsWireless Network Infrastructure Voice, Data and Vocera VLANsNetwork Sizing Switch Recommendations Deployments and ConfigurationBadge Configuration Tune AutoRF for Your Environment ∙ How do I know if the tranmit power is too hot or too cold? Wireless Network Infrastructure Configuration Create InterfacesWireless−Specific Configuration Create the Vocera Voice InterfaceWlan Configuration Wlan ConfigurationConfigure Access Point Detail AP DetailConfigure the 802.11b/g Radio Wireless IP Telephony Verification Association, Authentication, and Registration Common Roaming Issues Badge Loses Voice Quality while RoamingOne−sided Audio Audio ProblemsRegistration and Authentication Problems Choppy or Robotic AudioAP and Antenna Placement Appendix aSignal Reflection Caused by a Wall Cisco Aironet 5959 Antenna Mounted to a Ceiling Signal−to−Noise Ratio SNR Interference and Multipath DistortionNetPro Discussion Forums − Featured Conversations Signal AttenuationRelated Information