9Connect the Power and Turn On the Router
Follow these steps to connect power to the Cisco 800 series router and turn it on.
Figure 6 Connecting the Power to an 800 Series Router
HUB
NO HUB
ETHERNET 10 | BASE T |
|
0
1
2
3
Cisco 803
CONSOLE
ISDN S/T
PHONE
1 2
To electrical outlet
Desktop power supply
Step 1 Make sure the router power is off.
Step 2 Set the power switch to the STANDBY ( 
) position.
Step 3 Connect the power supply cable to the
Step 4 Connect the power cord to the desktop power supply.
Step 5 Connect the other end of the power cord to an electrical outlet.
Step 6 Turn ON the router. Press the power switch to on ().
10Verifying the LEDs
Verify the power connection and all other connections (links) by checking the LEDs in the table below. If the LEDs are not on, see the troubleshooting information in the Cisco 800 Series Routers Hardware Installation Guide.
Power/Link | LEDs To Check | Normal Patterns |
|
|
|
Power | OK | On |
|
|
|
To hub, server, PC, or workstation | Cisco 801 or Cisco 802 back panel: | On |
| LINK LED |
|
| Cisco 803 or Cisco 804 front panel: |
|
| LKØ, LK1, LK2, and LK3 LEDs |
|
|
|
|
To ISDN network using ISDN S/T port | LINE, CH1, or CH2 | On. CH1 or CH2 is on only when the router |
|
| has an active voice or data connection. |
|
|
|
To ISDN network using ISDN U port | NT1, LINE, CH1, or CH2 | On. CH1 or CH2 is on only when the router |
|
| has an active voice or data connection. |
|
|
|
To telephone, fax, or modem | PH1 or PH2 | On. PH1 or PH2 is on only when telephone, |
| You can also pick up the handset and | fax, or modem is in use. |
|
| |
| listen for a dial tone. |
|
|
|
|
|
| 9 |