Cisco Systems CISCO7206 quick start After Installation, Replace the Network Processing Engine

Page 24

6After Installation

This section contains hardware replacement instructions and information about contacting the Technical Assistance Center.

Note The Flash memory card, Flash Disk, and port adapters support online insertion and removal (OIR).

57014

2	2
	2
	1

1

Network processing engine

2

Captive installation screws

Replace the Network Processing Engine

1.Power down the router.

2.Disconnect the router from the power source.

3.On the network processing engine (NPE) (1), unscrew the captive installation screws (2).

4.Grasp the handle and pull the NPE from the chassis.

5.Insert the NPE and tighten the captive installation screws.

6.Connect the router to the power source and power up the router.

Also see the Network Processing Engine or Network Services Engine Installation and Configuration publication at http://www.cisco.com/univercd/cc/td/doc/product/core/7206/fru/npense/index.htm.

24

Image 24

Contents Cisco 7206 Router Quick Start Guide Documentation and Resources Document Revision HistoryDocumentation Survey Related DocumentationPort Adapter Documentation Other Useful Links Obtaining DocumentationWorld Wide Web Documentation CD-ROMOrdering Documentation Documentation FeedbackPrepare for Installation Site Preparation and UnpackingTools and Parts Preparing for Workbench or Tabletop Installation Preparing for Rack-Mount InstallationRack-Mount the Router Brackets Front-Mounted-Chassis Protrudes from the RackBrackets Front-Mounted-Chassis Recessed in Rack Cisco 7200 SeriesBrackets Rear-Mounted-Front Protrudes from the Rack Two-Post or Four-Post Rack Installation Brackets Rear-Mounted-Front Recessed in the RackChassis Ground Connection Installation Connect the Router to the Network Controller Console and Auxiliary Port Cable ConnectionsEthernet Port Connections Port Adapter Cable ConnectionsMII Connections RJ-45 ConnectionsStart and Configure the Router Power Cable ConnectionsConnecting AC-Input Power Connecting DC-Input Power57013 Starting and Configuring the Router Performing a Basic Configuration Using the Setup Facility Configuring Global ParametersFor the following query, do not enable Clns Page Configuring Interfaces Configuring Ethernet Interfaces No mop enabled Interface serial1/0 Saving the Running Configuration to Nvram Checking the Running Configuration SettingsViewing Your System Configuration Performing Complex Configurations Replacing or Recovering a Lost PasswordAfter Installation Replace the Network Processing EngineReplace the I/O Controller SeriesReplace the Flash Memory Card or Flash Disk Replace a Port Adapter or Service Adapter Replace the Power Supply Technical Assistance Cisco.comTechnical Assistance Center Cisco TAC Web SiteCisco TAC Escalation Center Page USA