Baracoda 2 manual Payload Response

		Data Capture
		for Workforce
		in Motion
	For each step:
	{(Bit 6: Blue LED 1) (Bit 5: Red LED 1) (Bit 4: Green LED 1) (Bit 2: Blue LED 0) (Bit 1: Red
	LED 0) (Bit 0: Green LED 0)}
	{Buzzer frequency, 0 – 0xFF * 50Hz = 0 – 12750Hz}
	{Delay until next step, in tenth of seconds}
Response	1 byte: {(Bit 0: Success)}
Code ID	0x8A-0x8B
Description	Play Signal
Payload	2 bytes:
	{Signal number, 0 - 3}
	{Number of loops, 0 – 0xFE, 0xFF = infinity}
Response	1 byte: {(Bit 0: Success)}
Code ID	0x8C-0x8D
Description	Stop Signal
Payload	1 byte:
	{Signal number, 0 – 3}
Response	1 byte:
	{(Bit 0: Success)}
The list of MMI signals is:
IHM_SIGNAL_CAPTURE_READ :		0
IHM_SIGNAL_CAPTURE_ACK :		1
IHM_SIGNAL_CAPTURE_NAK :		2
IHM_SIGNAL_CAPTURE_LOST :		3
Code ID	0x92-0x93
Description	Get Beeps mode
Payload
Response	1 byte:
	{(Bit 0: Beep level 0=low, 1=high)
	(Bit 1: Read beep)
	(Bit 2: ACK beep)}
Code ID	0x94-0x95
Description	Set Beeps mode
Payload	1 byte:
	{(Bit 0: Beep level; 0=low, 1=high)
	(Bit 1: Read beep)
	(Bit 2: ACK beep)
	(Bit 7 = 0: ACK beep config select, =1: ACK beep config deselect)
	(Bit 6 = 0: Read beep config select, =1: Read beep config deselect)
	(Bit 5 = 0: Beep level config select, =1: Beep level config deselect)}}

BaracodaPencil 2 – Communication Protocol v1.3 - 12 -