Baracoda 2 manual = upload data after retrieving

Page 17

Data Capture for Workforce in Motion

	{1 = upload data after retrieving}

Response	1 byte:
	{(Bit 0:Success)}

Comments	This is only available if no new scan has been made.


Code ID	0xD8-0xD9

Description	Enable remote trigger

Payload	None : use default 5s timeout
	1 byte : {timeout (s)}

Response	1 byte
	{(Bit 0:Success)}

BaracodaPencil 2 – Communication Protocol v1.3

- 17 -

Image 17

Contents BaracodaPencil Communication Protocol Summary Revision History Introduction Generalities ACK Control messagesNack SYNScanner to host messages Communication messages Host to scanner messagesRemarks Scanner messages 0x6A-0x6B User Interface messages Payload Response Byte Bit 0 Success BaracodaPencil 2 Communication Protocol Miscellaneous messages 0xC8-0xC9 Reserved = upload data after retrieving Capture messages Remark Stored barcodes count Select ALL Frame formatHeader Set Config Type B CommandType SizeLSB Free LSBFree Code 128 / EAN 128 Header C Interleaved 2 of 5 Header G MSI Header K MSB Free Get configType aUsual Commands Type D Code Commands TableSpecial Commands Special Commands Type EExamples Nd byte $01 Example 2.2 Setting a configuration of all symbologies Data Capture for Workforce in Motion Appendix 1 Bluetooth Protocol 0x01 if MASTER, 0x00 if SLAVE, Role switch Header Length Payload Response Command Set page scan timeout Set sniff Data Capture for Workforce in Motion Get Security Mode PDA FAX SPPDUN