Onkyo Master Your Audio Experience with Dolby Volume and Intellivolume Settings

Speaker Levels

■Subwoofer Level

`–15.0dBto 0.0dB to +12.0dB in 0.5 dB steps.

■Center Level

`–12.0dBto 0.0dB to +12.0dB in 0.5 dB steps.

You can adjust the volume of each speaker while listening to an input source.

These temporary adjustments are cancelled when the AV receiver is set to standby. To save the setting you made here, go to “Level Calibration” (➔ page 49) before setting the AV receiver to standby.

Note

•You cannot use this function while the AV receiver is muted.

•Speakers that are set to “No” or “None” in

“Speaker Configuration” (➔ page 48) cannot be adjusted.

Dolby Volume

■Dolby Volume

See “Dolby Volume” of “Audio Adjust” (➔ page 52).

Note

•This setting cannot be used in either of the following cases:

–Pure Audio or Direct listening mode is selected.

–the multichannel analog input is selected.

–any of the THX listening modes is selected, with “Loudness Plus” set to “On” or “Preserve THX Settings” set to “Yes” (➔ page 50).

•When “Dolby Volume” is set to “On”, the “Dynamic EQ” and “Dynamic Volume” settings of all input selectors are switched to “Off”.

En

Audyssey

■Audyssey

See “Audyssey” in “Source Setup” (➔ page 53).

■Dynamic EQ

See “Dynamic EQ” in “Source Setup” (➔ page 53).

■Dynamic Volume

See “Dynamic Volume” in “Source Setup” (➔ page 53).

Note

•These technologies can be used when all the following conditions are met:

–Room Correction and Speaker Setup is completed. Note that “Audyssey” requires the “Audyssey MultEQ XT Full Calibration” method.

–Any listening mode other than Direct or Pure Audio is selected.

–A pair of headphones is not connected.

–multichannel analog input is not selected.

•The setting is stored individually for each input selector.

•“Dynamic EQ” and “Dynamic Volume” cannot be selected when any of the THX listening modes is selected, with “Loudness Plus” set to “On” or “Preserve THX Settings” set to “Yes”.

•When “Dynamic EQ” is set to “On” or “Dynamic Volume” is set to anything else than “Off”, “Dolby Volume” will be switched to “Off”.

Late Night

■Late Night

For Dolby Digital and Dolby Digital Plus sources, the

options are:

`Off

`Low:

Small reduction in dynamic range.

`High:

Large reduction in dynamic range.

For Dolby TrueHD sources, the options are:

`Auto:

The Late Night function is set to “On” or “Off” automatically.

`Off

`On

Turn this setting on to reduce the dynamic range of Dolby Digital material so that you can still hear quiet parts even when listening at low volume levels—ideal for watching movies late at night when you don’t want to disturb anyone.

Note

•The effect of the Late Night function depends on the material that you are playing and the intention of the original sound designer, and with some material there will be little or no effect when you select the different options.

•The Late Night function can be used only when the input source is Dolby Digital, Dolby Digital Plus, or Dolby TrueHD.

•The Late Night function is set to “Off” when the AV receiver is set to standby. For Dolby TrueHD sources, it will be set to “Auto”.

64