Playback, Controlling Contents of USB or Network Devices

Playback

The on-screen menus appear only on a TV that is connected to the HDMI OUT MAIN. If your TV is connected to other video outputs, use the AV receiver’s display when changing settings.

This section describes the procedure for using the remote controller unless otherwise specified.

Selecting the Language for the Onscreen Setup Menus

You can determine the language used for the onscreen setup menus. See “Language” in the “OSD Setup” (➔ page 59).

Controlling Contents of USB or Network Devices

See “Controlling Other Components” about the operation of other components (➔ page 73).

Press USB or NET first.

Playing the Connected Component

■Operating with the remote controller

1	Press RECEIVER followed by INPUT
	SELECTOR.
2	Start playback on the source component.
	See also:
	• “Playing an iPod/iPhone via USB” (➔ page 24)
	• “Playing a USB Device” (➔ page 25)
	• “Listening to Internet Radio” (➔ page 25)
	• “Playing Music Files on a Server” (➔ page 27)
	• “Remote Playback” (➔ page 27)
	• “Listening to AM/FM Radio” (➔ page 28)
	• “iPod/iPhone Playback via Onkyo Dock”
	(➔ page 70)
	• “Controlling Other Components” (➔ page 73)
3	To adjust the volume, use VOL q/w.
4	Select a listening mode and enjoy!
	See also:

•“Using the Listening Modes” (➔ page 34)

•“Audyssey” (➔ page 53)

■Operating on the AV receiver

1	Use the input selector buttons to select the input
	source.
2	Start playback on the source component.
3	To adjust the volume, use the MASTER VOLUME
	control.
4	Select a listening mode and enjoy!