Cisco Hoot and Holler over IP
Configuration Examples
frame-relay interface-dlci 100 frame-relay ip rtp header-compression
!
interface Serial0/0.2 point-to-point ip address 5.5.6.1 255.255.255.0 ip pim sparse-dense-mode frame-relay class hoot-n-holler frame-relay interface-dlci 101 frame-relay ip rtp header-compression
!
map-class frame-relay hoot-n-holler frame-relay cir 128000 frame-relay bc 1280
frame-relay mincir 128000 frame-relay fragment 160
frame-relay ip rtp priority 16384 16384 128 no frame-relay adaptive-shaping
!
voice-port 1/0/0 voice-class permanent 1 connection trunk 111 music-threshold -30 operation 4-wire
!
dial-peer voice 1 voip destination-pattern 111 session protocol multicast
session target ipv4:237.111.0.0:22222 ip precedence 5
Router-2
The following output shows that Router 2 has been configured for Cisco hoot and holler over IP with a Frame Relay topology:
hostname Router-2
!
ip multicast-routing
!
voice class permanent 1
signal timing oos timeout disabled signal keepalive 65535
!
interface Vif1
ip address 2.2.2.2 255.255.255.0 ip pim sparse-dense-mode
!
router rip network 2.2.2.0 network 5.5.5.0
!
interface Serial0/0 no ip address
ip pim sparse-dense-mode encapsulation frame-relay frame-relay traffic-shaping no frame-relay broadcast-queue
!
interface Serial0/0.1 point-to-point ip address 5.5.5.2 255.255.255.0 ip pim sparse-dense-mode frame-relay class hoot-n-holler
Cisco IOS Voice, Video, and Fax Configuration Guide
