Cisco Systems 300 quick start Returning the Device to the Factory Default Settings, Back Panel

Page 11

Back Panel

The power port and console port are located on the back panel of the managed switch.

Power—The Power port is where you will connect the switch to power.

Console—The Console port is where you can connect a serial cable to a computers serial port for configuration using a terminal emulation program.

Returning the Device to the Factory

5 Default Settings

To use the Reset button to reboot or reset the managed switch, do the following:

•To reboot the managed switch, press the Reset button for less than 10 seconds.

•To restore the managed switch configuration to the factory default settings:

1.Disconnect the managed switch from the network or disable all DHCP servers on your network.

2.With the power on, press-and-hold the Reset button for more than 10 seconds.

300 Series Managed Switches

11

Page 10 Page 12
Image 11
Page 10 Page 12
Contents Quick Start Guide Welcome Mounting the Cisco SwitchWall Mounting Rack-Mount PlacementPower over Ethernet PoE Considerations Connecting Network DevicesUse the Web-Based Interface Configuring the Cisco Small Business Managed SwitchBefore You Begin Managed Switch Login Page displays Next Steps Use the console portTroubleshoot Your Connection Possible Causes and ResolutionsNo IP route Front Panel PortsFront Panel LEDs Additional Front Panel FeaturesBack Panel Returning the Device to the Factory Default SettingsSupport Where to Go From HereSeries Managed Switches Series Managed Switches Series Managed Switches Americas Headquarters
Top Page Image Contents