Chapter 1
Product Overview
Reset There are two ways to reset the Router’s factory defaults. Either press and hold the Reset Button for approximately five seconds, or restore the defaults from the Administration > Factory Defaults screen in the Router’s
Administration > Factory Defaults, page 32).
Power Switch Press I the end to power on the Router. Press the O end to power off the Router.
Power The Power port is where you connect the power adapter.
Horizontal Placement
The Router has four rubber feet on its bottom panel. Place the Router on a level surface near an electrical outlet.
Wall-Mounting Placement
The Router has two
Two screws are needed to mount the Router.
Suggested Mounting Hardware
††Note: Mounting hardware illustrations are not true to scale.
NOTE: Linksys is not responsible for damages incurred by unsecured
Follow these instructions:
1.Determine where you want to mount the Router. Make sure that the wall you use is smooth, flat, dry, and sturdy. Also make sure the location is within reach of an electrical outlet.
2.Drill two holes into the wall. Make sure the holes are 175.56 mm (6.91 inches) apart.
3.Insert a screw into each hole and leave 3 mm (0.12 inches) of its head exposed.
4.Position the Router so the
5.Place the
175.56mm
(6.91 in)
Print this page at 100% size.
Cut along the dotted line, and place on the wall to drill precise spacing.
Simultaneous | 4 |