![](/images/new-backgrounds/1174427/17442719x1.webp)
Caller ID on Cisco 2600 and 3600 Series Routers and Cisco MC3810 Multiservice Concentrators
Caller ID Configuration Task List
To configure the alerting method, use the following commands beginning in global configuration mode. Configuration of the alerting method is required when the caller ID standard, specified by locale through the cptone command, is other than Bellcore/Telcordia (if you do not configure the alerting method, the default
| Command | Purpose |
Step 1 |
|
|
Router(config)# | Enters | |
|
| MC3810 multiservice concentrator. The slot |
|
| number for analog voice ports on the Cisco |
|
| MC3810 multiservice concentrator is always 1. |
| or | There is no port 0 for voice ports. |
| Router(config)# | Enters |
| 2600 or 3600 series router. | |
| ||
Step 2 |
|
|
Configure this command on FXO ports where | ||
| alerting ring {1 2} | caller ID information is received from a subscriber |
|
| telephone line. and on FXS voice ports from which |
|
| caller ID information is transmitted to an attached |
|
| telephone device. |
|
| Compatible settings are required on both ends of |
|
| the telephone line connection or caller ID |
|
| information may not be displayed. |
|
| Enter 1 if your telephone line service provider or |
|
| telephone device specifies it, to provide or expect |
|
| caller ID information following the first ring at the |
|
| receiving station. This is the default setting. |
|
| Enter 2 to provide or expect |
|
| during the long ring pause following two short |
|
| rings. This setting is used in Australia and the |
|
| United Kingdom. |
Step 3 |
|
|
(FXS ports only) Configure this setting only when | ||
| the attached telephone device requires line polarity | |
|
| reversal to signal the start of |
|
| transmission. |
|
|
|
Cisco IOS Voice, Video, and Fax Configuration Guide