Cisco Systems 2600 appendix Command Option Country, VC-816

Command

Purpose

Step 3

Router(config-voiceport)# voice confirmation-tone

Enables the two-beep confirmation tone that a

caller hears when picking up the handset, if

connection plar or connection plar-opx is

configured.

Step 4

Router(config-voiceport)# dial-type{dtmf pulse}

(For FXO ports only) Selects the appropriate dial

type for out-dialing.

Step 5

Router(config-voiceport)# signal {loop-start

Selects the appropriate signal type for this

ground-start}

interface.

Step 6

Router(config-voiceport)# codec {g729r8 g729ar8

(Cisco MC3810 multiservice concentrator only)

g726r32 g711alaw g711ulaw}

Configures the voice-port compression mode. The

g729ar8 value is the default and is recommended.

Note On Cisco 2600 and 3600 series routers,

codec configuration is performed on dial

peers. On all supported routers, codec

command options may vary depending

upon the voice card settings.

Step 7

Router(config-voiceport)# cptone locale

Selects the appropriate voice call progress tone for

this interface. Caller ID requires this setting. The

caller ID standard (Bellcore/Telcordia, ETSI,

ETSI-DTMF) is determined by this command.

On the Cisco MC3810 multiservice concentrator,

the default setting for locale is northamerica. On

Cisco 2600 and 3600 series routers, the default

setting for locale is us.

See Table 57 on page 816 for a list of options.

Step 8

Router(config-voiceport)# ring frequency {25 50}

(Required on Cisco 2600 and 3600 series routers

FXS ports only) Selects the appropriate ring

frequency (in hertz) specific to the equipment

attached to this voice port.

Step 9

Router(config-voiceport)# caller-id attenuation

(Optional on FXO ports only) Specifies an

attenuation

attenuation other than the default of 14 dB (minus

14 dBm), enter a value of from 0 to 64, in decibels.

Step 10

Router(config-voiceport)# ring number number

(Required on Cisco 2600 and 3600 series routers

FXO ports only) Specifies the maximum number

of rings to be detected before answering a call.

Command Option

Country

Command Option

Country

ar

Argentina

lu

Luxembourg

au

Australia

my

Malaysia

at

Austria

mx

Mexico

be

Belgium

nl

Netherlands