Cisco Systems 2100 quick start Rack Mount the Hardware

Rack Mount the Hardware

	LINK	100Mbps	LINK
				100Mbps
MODE
CONS	ETHERNET 0				DRIVE 0
			ETHERNET 1			DRIVE 1

Phillips machine screws

Installing Rack Mount

Hardware

This section describes how to install the

IE2100 Series in a standard 19-inch equipment rack.

A rack-mount kit is included for mounting the system in a standard 19-inch equipment rack with two unobstructed outer posts.

Note You can place the system on a desktop or other flat, stable surface. Self-adhesive rubber feet are provided for this purpose.

Warning The following guidelines are provided to ensure your safety:

•This unit should be mounted at the bottom of the rack if it is the only unit in the rack.

•When mounting this unit in a partially filled rack, load the rack from the bottom to the top with the heaviest component at the bottom of the rack.

•If the rack is provided with stabilizing devices, install the stabilizers before mounting or servicing the unit in the rack.

Intelligence
Engine
2100	Series	49336

To install the IE2100 Series in a rack:

Step 1 Measure the rack to verify that the system will fit.

Step 2 Attach the L brackets to the sides of the chassis using the provided screws so that the L-bracket mounting surfaces are even with the front or back panel of the chassis, depending on which way you want to install it.

Step 3 Position the chassis in the rack.

Step 4 Align the four mounting holes in the

L bracket with the four mounting holes in the equipment rack.

Step 5 Secure the system in the rack by installing the provided screws through the elongated holes in the L bracket and into the threaded holes in the mounting post.

3