Emulex 4 Gb FC Host Bus manual Removing the Bracket Screws

Page 12

The single channel SG-XPCIE1FC-EM4 will have one IEEE address, the dual channel SG-XPCIE2FC-EM4 will have two IEEE addresses. The IEEE address is used when configuring your system. The serial number is used when communicating with Sun. All numbers are clearly marked on the board. Record these numbers before installation.

2.Shut down, power off, and unplug the computer.

3.Remove the computer case.

4.Remove the blank panel from an empty PCI Express slot.

5.(Optional) Perform the following steps to replace the PCI bracket.

Note – The HBA comes with a low-profile PCI bracket installed. This bracket is approximately 3.11 in. (7.9 cm) long. A standard mounting bracket, which is approximately 4.75 in. (12.6 cm), is provided with each X-option order.

a. Remove the mounting bracket screws from the HBA (see FIGURE 2).

FIGURE 2 Removing the Bracket Screws

b. Remove the bracket and store it for future use.

c. Align the new mounting bracket tabs with the holes in the HBA.

Note – Be careful not to push the bracket past the transceiver housing’s grounding tabs. Ensure that the LEDs are properly aligned with the holes in the bracket.

d. Replace the screws that attach the HBA to the bracket.

6.Insert the HBA into the empty PCI Express 4-lane slot. Press firmly until the adapter is seated.

4 Sun StorageTek PCI Express Enterprise 4 Gb FC HBA Emulex Installation Guide • December 2005

Image 12

Contents Sun Microsystems, Inc Please Recycle Contents Page Using Unix Commands How This Book Is OrganizedShell Prompts Typographic ConventionsRelated Documentation Accessing Sun Documentation Third-Party Web SitesContacting Sun Technical Support Sun Welcomes Your Comments Installing, Connecting, and Testing the Host Bus Adapter System RequirementsInstalling the HBA To Verify the Packaging ContentsTo Install the HBA Hardware Record Ieee and serial numbersRemoving the Bracket Screws Optical Cable Specifications To Attach the Optical CableWhen attaching the optical cable, be sure to To Apply Power To Verify Proper Installation in Sparc PlatformsPage Installing, Connecting, and Testing the Host Bus Adapter Page Installing, Connecting, and Testing the Host Bus Adapter To Verify Attached Storage to the Installed HBA Show-children Installing the HBA Driver with the Solaris 10 OS PackagesSun Product Information Page at Emulex PatchesDiagnostic Support P E N D I X a Page Declaration of Conformity Page Regulatory Compliance Statements FCC Class a NoticeFCC Class B Notice ICES-003 Class a Notice Avis NMB-003, Classe a ICES-003 Class B Notice Avis NMB-003, Classe BBsmi Class a Notice CCC Class a NoticeGOST-R Certification Mark Safety Agency Compliance Statements Safety PrecautionsSymbols Placement of a Sun Product Noise LevelPower Cord Connection Battery WarningSelv Compliance System Unit CoverConformité aux normes de sécurité Conformité Selv Connexion du cordon d’alimentationMise en garde relative aux batteries Couvercle de lunitéAvis de conformité des appareils laser Mise en garde relative au système en rackEinhaltung sicherheitsbehördlicher Vorschriften Anschluss des Netzkabels Warnung bezüglich Batterien GehäuseabdeckungWarnungen bezüglich in Racks eingebauter Systeme Normativas de seguridad Hinweis zur Laser-KonformitätCD- und DVD-Geräte Medidas de seguridadColocación de un producto Sun Nivel de ruidoCumplimiento de la normativa para instalaciones Selv La utilización de láser Nordic Lithium Battery Cautions