Avenview SW-HDM3D-C5-4X4 Regulatory Notices Federal Communications Commission FCC, Introduction

Page 4

1.3Regulatory Notices Federal Communications Commission (FCC)

This equipment has been tested and found to comply with Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

Any changes or modifications made to this equipment may void the user’s authority to operate this equipment.

1.4Introduction

The Avenview SW-HDM3D-C5-4X4, HDMI Matrix Switch with 3D over CAT-5 with IR Pass-Through provides the most flexible and cost effective solution in the market to route high definition video sources plus multi-channel (up to 7.1 channel) digital audio from any of the four HDMI sources to the remote displays at the same time. Through low cost Cat-5/5e/6 LAN cables, not only high quality video and audio can be transmitted to the display sites, but also users can switch among four HDMI sources using the push-in button or remote control. With single power design at the source site, each remote module is easily installed without power supply. Furthermore, the built-in IR extension function makes users at display site access the DVD player, PS3 or any HDMI supported devices directly.

www.avenview.com

4

 

 

Image 4
Contents Model # SW-HDM3D-C5-4X4 Table of Contents Important Safeguards Safety InstructionsRegulatory Notices Federal Communications Commission FCC IntroductionPage Package Contents Before InstallationSW-HDM3D-C5-4X4 Front Panel Panel DescriptionSW-HDM3D-C5-4X4 Rear Panel 3 HDM3D-C5SW-R Dip Switch for Edid & Audio Settings SW1 SW4 DIP Switch Position Video Audio Description PIN #SW Main Dip Switch for Firmware Update DIP Switch Position PIN #IR Control Patch IR Transmitter Cable IR Receiver Cable IR MainInstallation SW-HDM3D-C5-4X4 Operation and IR Control Source Side11 RS232 Serial Port Control ScanOutput Port 11.1RS232 Commands Group settingSpecifications Page Page Disclaimer