Avenview DVI-SPLITPRO-2BB IR Remote Control, Swap between main channel and sub-channel

10.Plug in power adapter cable into 5V DC power jack.

11.Switch on all devices connected and then switch on the video processor and then press “menu” to display OSD menu.

12.Press down arrow key dropping down sub-menu to select the first channel (Main Channel) video/graphic source.

13.Once the Main Channel has a video selected, press “exit” key to exit the sub-menu, and then move right to the next item of OSD menu, which allows you to select the second channel (Sub Channel).

14.For detailed IR remote control operation, please refer to the On Screen Display menu and IR Remote Control section.

2.1IR Remote Control

DVI-SPLITPRO-2B ships with a compact remote control that allows for direct access to most commands used to control the video processor.

1.	Power	Power ON/OFF the device
2.	PIP Border	Display the border of small image (under PIP
		mode)
3.	UP Button	Move to the upper titles
4.	Source	Press to select a source for main channel
5.	Reset	Factory Reset
6.	Right Button	Move to the right titles
7.	Menu	Display OSD Menu
8.	Left Button	Move to the left titles
9.	Logo	Display Logo
10.Exit		Move back to previous option or exit OSD Menu
11.Down Button		Move to the lower titles
12.Enter		Press to drop down sub-menus or confirm the
		selection
13.Blank		Blank out the screen
14.Color		Automatically configure the main channel color
15.Auto		Automatically configure the man channel position
16.V Flip		Flip vertically
17.H Flip		Flip Horizontally
18.SWAP		Swap between main channel and sub-channel
		(only works in PIP or PAP mode)
19.PIP		Changes mode: Full Screen, PIP and PAP
20.Sub Pause		Freeze sub-channel

21.Main Pause Freeze main channel

www.avenview.com 10