Extron electronic VSC 100 user manual Troubleshooting Tips

Making Connections to and Operating the VSC 100 • Chapter 2

S-video/RGB switch – Set this switch for the type of output for your application: up for S-video or down for RGB.

Signal Lock LED – Off = no signal; Blinking = signal is out of range; On = signal is within range.

Troubleshooting Tips

No image or picture –

1.Make sure all cable connections are correct and tight.

2.Confirm that only compatible scan rates are coming into the VSC 100.

Picture too bright –

1. Set 75 Ohm DIP switch (rear) to the 75 Ohm position (up).

Picture too dark –

1.Set 75 Ohm DIP switch (rear) to the off position (down).

2.Disconnect any output cables that are not being used. (Do not have cables connected to both S-video and RGB (R-Y/Y/B-Y) at the same time.

No color on display screen –

1.Adjust the hue/tint and color controls on the display device.

2.Be sure to use video equipment that matches the format (NTSC, PAL etc.).

Poor recording quality –

1.Adjust the sharpness control on the VCR.

2.Record using the S-video output of the VSC 100.

2-7 VSC 100 • User’s Manual • Extron