Installation and Operation, cont’d
Mounting the Interfaces
Select the installation site. Take cabling and power availability into consideration. Select an installation option: tabletop/desktop placement, or
Tabletop/desktop placement
For tabletop or desktop placement only, install the self- adhesive rubber feet/pads (provided) onto the four corners of the bottom of the interface enclosure.
Under-desk mounting
1.Attach the mounting brackets to the interface with the provided machine screws, as shown below.
2.Hold the interface with attached brackets against the underside of the desk or other furniture. Mark the location of holes for screws on the desk.
3.Drill 1/4” (6.4 mm) deep, 3/32” (2.38 mm) diameter pilot holes in the table or desk at the marked screw locations from the underside/inside (concealed side) of the furniture, where the interface will be located.
4.Attach the interface to the installation surface with the provided wood screws, as shown below.
| 138 | xi |
RGB |
| |
|
|
Through-desk mounting
1.Attach the
2.Hold the interface with attached brackets against the underside of the mounting surface of the desk or table. With a soft pencil mark the location of holes for screws on the desk. Mark the opening, approximately 17.63” x 1.88” (44.77 cm x 4.76 cm).
3.Cut out the material from the installation area with a jigsaw. Check the opening size by inserting the interface part way through the hole. If needed, use a saw, file or sandpaper to enlarge the hole. Smooth the edges of the hole with sandpaper.
4.Drill 1/4” (6.4 mm) deep, 3/32” (2.38 mm) diameter pilot holes in the desk or table at the marked screw locations. The holes should be drilled from the underside or inside (concealed side) of the furniture, where the interface will be located.
5.Attach the interface to the desk with the provided wood screws, as shown in the illustration below.
ix | 831 |
|
|
| BGR |
To adjust the height of the interface within the desk, slightly loosen the screws that attach the brackets to the interface, adjust the height by sliding the interface up or down, and retighten the screws.
RGB 138xi, RGB 158xi Installation and Operation |