Extron electronic RGB 560/Dual, RGB 568, RGB 500/Dual, RGB 508 user manual Specifications

Page 16

Specifications

Video

Gain	Unity (0.70V p-p), (0.725V p-p) 50%
	peaking, (0.75V p-p) 100% peaking
Bandwidth	300 MHz (-3dB)

Video input

Number/signal type	1 analog RGBHV, RGBS, RGsB, RsGsBs
Connectors

RGB 500, RGB 500 Dual, RGB 508, RGB 500 AKM

1 9-pin D male, MBC/LBC cable or buffer

RGB 560, RGB 560 Dual, RGB 568, RGB 560 AKM

	1 15-pin HD female
Minimum/maximum levels	Analog	0.3V to 1.5V p-p with no
		offset
Impedance	75 ohms or High Z, switchable (set to 75
	ohms if no local monitor is connected)
Horizontal frequency	Autoscan 15 kHz to 130 kHz
Vertical frequency	Autoscan 30 Hz to 120 Hz
Return loss	-30dB @ 5 MHz
Maximum DC offset	4.0V

Video output

Number/signal type	1 analog RGBHV, RGBS, RGsB
Connectors
All models	5 BNC female

RGB 560, RGB 560 Dual, RGB 568, RGB 560 AKM

115-pin HD female for buffered local monitor output

Minimum/maximum levels	0.70V to 0.75V p-p with no offset and 0.7V
	p-p input
Impedance	75 ohms
Return loss	-30dB @ 5 MHz

Sync

Input type	RGBHV TTL (±), RGBS TTL (-), RGsB 0.3V
	(-), RsGsBs 1.3V (-)
Output type	RGBHV (±), RGBS(-), RGsB (-)
Input level	2V to 5.5V p-p with ±0.3VDC offset (max.)
Output level	4V to 5V p-p
Input impedance	10 kohms
Output impedance	75 ohms
Max. input voltage	5.7V p-p
Max. propagation delay	48 nS

Max. rise/fall time	3.5 nS
Polarity
AKM models	RGBHV	Polarity follows
		input when RGBHV
		is input and the sync
		polarity switch is set
		to Off. Sync polarity
		is negative if the
		sync polarity switch
		is set to On.
	RGBS, RGsB	Negative
All other models	RGBHV	Polarity follows
		input when RGBHV
		is input and the
		bottom panel sync
		polarity jumper is
		set to follow (pin 1
		jumpered to pin 2).
		Sync polarity is
		negative if the sync
		polarity jumper is
		set to negative (pin 2
		jumpered to pin 3).
	RGBS, RGsB	Negative

Audio

Gain	Unbalanced 0dB, balanced +6dB
Frequency response	20 Hz to 20 kHz, ±0.05dB
THD + Noise	0.03% @1 kHz, 0.3% @ 20 kHz at rated
	maximum output drive
S/N	>90dB at rated maximum output (14dBm),
	balanced
Stereo channel separation	>95dB @ 1 kHz to 20 kHz

Audio input

Number/signal type	1 PC level stereo, unbalanced
Connectors	1 3.5 mm stereo jack, 2 channel; tip (L),
	ring (R), sleeve (ground)
Impedance	10 kohms, DC coupled
Maximum level	+8.5dBu, (unbalanced) at stated %THD+N

Audio output

Number/signal type	1 stereo (2 channel), balanced/unbalanced
Connectors	1 3.5 mm stereo captive screw connector,
	5 pole, for left and right output

A-2

RGB 500 Series • Specifications

RGB 500 Series • Specifications

A-3

Image 16

Contents RGB 500/Dual, RGB RGB 560/Dual, RGB Extron’s Warranty PrecautionsFCC Class a Notice Table of Contents Introduction Table of Contents, cont’dRGB 500 Series Features IntroductionAbout this Manual About the RGB 500 Series InterfacesInstallation and Operation Introduction, cont’dInstallation and Operation Installing the RGB 500 Series InterfacesInstallation and Setup Overview Installation and Operation InstructionsInstallation and Operation, cont’d Installing the mounting bracket with clipsInstalling the mounting bracket with screws Setting bottom and top panel switchesBottom panel features Audio output captive screw connector This 3.5 mm, 5-poleWiring a captive screw connector for audio output Vertical sync width jumper switch This jumper switchTop panel jumper switches Ddsp Digital Display Sync ProcessingSerr serration pulse Composite syncInstalling optional adapter plates Attaching adapter platesSetting front panel switches Front panel features RGB 500 series, RGB 508 seriesComputer video input 9-pin D male connector Front panel features RGB 560 series, RGB 568 series Connecting input cables = on = OFF = on and 2 = on orPre-installation testing/troubleshooting Mounting the interface to the mounting bracketAttaching the faceplate SpecificationsAAppendix a Specifications Specifications, cont’d Enclosure dimensions RGB 500 AKM, RGB 560 AKMRough-in Templates GeneralRGB 500 and RGB 560 Rough-in Template Rough-in TemplatesRGB 500 Series Rough-in Dimensions Rough-in Templates, cont’dRGB 500 and RGB 560 Faceplates DimensionsRGB 500 Dual and RGB 560 Dual Faceplates Accessories and Part Numbers Dimensions, cont’d RGB 508 and RGB 568 FaceplatesRGB 508 faceplate dimensions RGB 568 faceplate dimensionsAccessories and Part Numbers Power SupplyInterfaces Optional Adapter PlatesSingle Type Connector Architectural Adapter Plates PartAccessories and Part Numbers, cont’d CablesOther Accessories CategoryAccessories and Part Numbers, cont’d