Extron electronic MTP Series setup guide Signal Jumpers for Generational Compatibility

Signal Jumpers for Generational Compatibility

The latest generation MTP transmitters convert stereo audio to mono before outputting it to the receiver. Remote powering of either the transmitter or receiver has also been eliminated. While the default setup of a new generation (mono audio) MTP transmitter/receiver is not compatible with older generation (stereo audio) units, internal jumpers provide backward compatibility and also allow new generation units to utilize the two features (stereo audio and remote powering) when necessary.

Shift the new transmitter and/or receiver jumper if:

•The installation mixes a transmitter/receiver pair with stereo and mono audio (old and new generation).

•Stereo audio is required.

•Remote power is needed.

The table below identifies the generation of transmitter and/or receiver. If any of the above scenarios are true, consult the VersaTools MTP Series User's Manual or www.extron.com for instructions on properly setting the jumper.

NOnly new generation units have jumpers.

Transmitter	Old generation	New generation
	(stereo audio)	(mono audio)
MTP T SV	60-540-02	60-540-42
MTP T SV A	60-540-22	60-540-52
MTP T SV A RCA	60-541-32	60-540-62
MTP T SV A AAP	70-362-02, -03	70-362-22, -23
MTP T CV	60-540-01	60-540-41
MTP T AV	60-540-21	60-540-51
MTP T AV RCA	60-540-31	60-540-61
MTP T AV AAP	70-361-02, -03	70-361-22, -23

Receiver	Old generation	New generation
	(stereo audio)	(mono audio)
MTP R SV	60-541-02	60-541-42
MTP R SV A	60-541-22	60-541-52
MTP R SV A RCA	60-541-32	60-541-62
MTP R CV	60-541-01	60-541-41
MTP R AV	60-541-21	60-541-51
MTP R AV RCA	60-541-31	60-541-61

VersaTools ® MTP Series • Installation 1-3

Refer also to the VersaTools ® MTP Series User’s Manual at www.extron.com.