Philips AZ102H, AZ102F user manual Power Supply General Operation, Batteries not included

Page 6

Power Supply

General Operation

Power Supply

Whenever convenient, use the power supply cord if you want to conserve battery life. Make sure you remove the plug from the set and wall outlet before inserting batteries.

Batteries (not included)

1Open the battery door and insert 6 batteries, type R-14, UM-2or C-cells, (preferably alkaline) with the correct polarity as indicated by the "+" and "" symbols inside the compartment.

2Replace the battery door, making sure the batteries are firmly and correctly in place.The set is now ready to operate.

Batteries contain chemical substances, so they should be disposed of properly.

Incorrect use of batteries can cause electrolyte leakage and will corrode the compartment or cause the batteries to burst:

Do not mix battery types: e.g. alkaline with carbon zinc. Only use batteries of the same type for the set.

When inserting new batteries, do not try to mix old batteries with the new ones.

Remove the batteries if the set is not to be used for a long time.

Using AC power WARNING:Always check you have completely switched off the set, before you change or disconnect power supply.

1Check if the power voltage, as shown on the type plate located on the bottom of the set, corresponds to your local power supply. If it does not, consult your dealer or service center.

2Connect the power cord to the AC MAINS~ inlet and the wall socket.The set is now connected and ready for use.

3To switch the set off completely, withdraw the power cord from the wall socket.

4Install the unit near the AC outlet and where the AC power plug can be easily reached.

Disconnect the power cord from the wall socket to protect your set during heavy thunderstorms. Children could seriously injure themselves as the free end of the cable may still be live if only the connector is removed from the MAINS socket at the back of the unit.

The type plate is located on the bottom of the set.

Helpful hints:

To avoid unnecessary energy consumption, always adjust the Source selector to OFF after using the set.

Image 6
Contents CD Soundmachine Dynamic Bass Boost R14 UM-2 C-CELLS ALL Top/front panels See English Controls/Power SupplySupplied Accessories Back/bottom panel SeePower Supply General Operation Power SupplyBatteries not included Radio reception Tuner CD PlayerGeneral operation Playing a CDProgramming track numbers Selecting a different trackFinding a passage within a track Reviewing the programDifferent play modes REPEAT. and Shuffle See 6 RepeatMaintenance & Safety See Safety informationCD player and CD handling No sound /power CD skips tracks TroubleshootingProblem Er or 01 indicationSpecifications Mains plug How to connect a plugImportant notes for users in the U.K Copyright in the U.KClass Laser Product