Hughes Installation | Configuration and Connections |
|
|
|
|
Connecting System 4xi to Hughes/JVC Projectors
[System
4
mode
l and
software 
version
display
ed here] 
(See note.)
(See note.) |
(See note.)
(See note.) |
(Note: Information depends on System 4 setup.)
If the System 4xi is already configured for a Hughes/JVC projector, go to step 4. If it is not set up correctly, it will be necessary to change switch settings on the System 4xi ’s Main Controller Board. Begin at Step 1 to verify the correct configuration.
1.Use the Front Panel to display the Information Menu to verify that the System 4xi is already set up for the Hughes/JVC projector. Apply power to the System 4xi and do the following:
a.Press 
to display the MENU SELECT on the LCD screen.
b.Press 
or 
to step to Menu 8.
} | c. Press |
| to select this menu. |
| |||
| |||
d. Press | or to display the configuration. The example to the left is general, | ||
yours will show the System 4xi model name, the software version and the | |||
following information: | |||
PRJ = HUGHES | |||
| PRJ BAUD = 19200 | ||
UNIT No.= 000
HST BAUD = 9600 (value depends upon setup Menu 3)
2.Go to the procedure on page
Config | Projector | SW1: | SW2 | SW3 | SW4 | SW5 | SW6 | Prj Cable | Comm |
as |
|
|
|
|
|
|
|
| Adapter |
|
|
|
|
|
|
|
|
|
|
✔ | 0 | 0 | 5 | 6 | 0 | J15 | |||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
SW3 |
SW2 |
SW4 |
SW5 |
J15
SW1
4 | 3 | 2 | 1 |
ON
3.
4.Install the System 4xi in its place of operation (i.e. rack), but do not connect the power cable.
__________ Changes in some switch configurations are not detected until the power is
removed at the AC cord, and then restored.
Follow the correct cable connection diagram for your Hughes projector and continue the installation.
5.The UNV ADP, “A”
Extron • System 4xi Switcher Series • User’s Manual • P/N | Page 1 |