Extron electronic P/N 68-412-02 specs

Hughes Installation	Configuration and Connections

6.Plug the 15-pin HD connector of the Projector Communications Extension cable (CC 50' or CC 100') into the PJ Comm port on the System 4. The other end has a 9-pin female connector. Plug this end into the other 9-pin male D connector on the HU COM adapter.

______ Secure all of the connector screws.

7.Plug the (4 or 5) BNC connectors from one end of the (user-supplied) RGBS/HV cable onto the System 4 output and those on the other end onto the matching

BNCs on the Hughes panel. See cable diagram in Figure 2-18a or 2-18b.

____________ If installing the Hughes HJT 100/200, you must also follow the special setup

instructions on page 4.

System 4xi - Hughes/JVC Model 300/400 Series Connections

Use illustration below as a guide when connecting the System 4xi to a Hughes/ JVC model 400 projector. Refer to Hughes/JVC documentation to continue the installation.

	ADP UNV "A"	"A"
	26-467-01	"A"
	26-467-01

Connecting the System 4xi to a Hughes/JVC Model 400 Projector

____________ In a rack mount, do NOT allow the weight of the cables to be supported by the

System 4xi. See page 2-5 for cabling guidelines.

Extron • System 4xi Switcher Series • User’s Manual • P/N 68-412-02 Rev. A

Page 2