Extron electronic MTPX 1632, MTPX 1616 Introduction, About this Manual, About the Mtpx Switchers

Page 6

Introduction

About this Manual

This setup guide allows you to easily and quickly set up and configure your Extron MTPX Twisted Pair (TP) Matrix Switcher. Step by step instructions show you how to connect the hardware, and then use the physical controls and the Matrix Switchers Control Program to optimize the video and audio output for the best quality.

About the MTPX Switchers

The MTPX matrix switcher (figure 1-1) distributes signals that are compatible with the Extron MTP and VTT/VTR product lines. The matrix switcher routes a TP input signal to any combination of TP outputs. Depending on the MTP model, the routed TP signal can include RGB or low resolution video and either mono audio or transmitter-to-receiver RS-232 serial communications. The matrix switcher can route multiple input/output configurations simultaneously.

Monitor

Control

Extron

 

MTP U R RSA SEQ

 

System

 

 

Universal Receiver

Plasma / LCD

Display

Rack Mounted PC

Extron

 

 

 

 

MTPX 3232

 

 

 

Extron

Twisted Pair

 

 

 

MTP U R A

Matrix

 

 

A

Universal

Switcher

U

R

 

Receiver

 

MTP

 

 

 

 

 

 

 

LCD projector

NThe receiver-to-transmitter serial communications and remote power capabilities available with certain MTP models are not supported by this matrix switcher.

The MTPX matrix switcher is available in the following matrix sizes:

•

MTPX 816

(8 inputs by 16 outputs)

•

MTPX 168

(16 inputs by 8 outputs)

•

MTPX 1616

(16 inputs by 16 outputs)

•

MTPX 1632

(16 inputs by 32 outputs)

•

MTPX 3216

(32 inputs by 16 outputs)

•

MTPX 3232

(32 inputs by 32 outputs)

The MTPX switchers input and output TP signals on RJ-45 connectors.

NFor best results, use a cable length of at least 50' (15 m) between the TP inputs and outputs and the transmitter and receiver.

Three or six (depending on the matrix size) 15-pin HD and

5-pole 3.5 mm direct insertion input connectors are available for direct RGB (VGA) and stereo audio inputs without an MTP transmitter.

One or two (depending on the matrix size) 15-pin HD output connectors are available for direct RGB (VGA) output to a video device without an MTP receiver.

NThe direct input and direct output 15-pin HD connectors can also support HD-YUV video, YUV video, S-video, and composite video.

Four or eight (depending on the matrix size) 5-pole 3.5 mm captive screw ports are available for direct mono audio outputs

Sound System

Extron

MTP T SV A

Transmitter

 

Extron

DVD

MTP T 15HD A

 

Transmitter

T 15H

D RS

 

MTP

Extron

MTP T 15HD RS

Receiver

PC

to an audio device without an MTP transmitter.

NFor low resolution MTPs (S-video and composite video) on the TP inputs and outputs, the MTPX audio circuits are compatible only with the newer generation, mono audio models. See the MTP transmitter/ receiver to determine which MTP models you have.

The matrix switcher can be remotely controlled via ieither of two serial ports using either Extron’s Windows®-based Matrix Switchers Control Program or the Simple Instruction Set (SIS™).

PC

Figure 1-1 — Typical MTPX Twisted Pair Matrix Switcher application

1-2 MTPX • Introduction

MTPX • Introduction

1-3

Refer also to the MTPX User’s Manual at www.extron.com.

Refer also to the MTPX User’s Manual at www.extron.com.

Page 5 Page 7
Image 6
Page 5 Page 7
Contents Setup Guide Mini Twisted Pair Matrix SwitchersPrecautions Extron’s Warranty安全须知 中文 FCC Class a NoticeTable of Contents One Mtpx Twisted Pair Matrix SwitcherTable of Contents, cont’d IntroductionAbout this Manual About the Mtpx SwitchersIntroduction MtpxRecommended transmission distances at 60 Hz Video format Mtpx Pre-Peak Maximum distance Off HighInstallation TwoIntroduction, cont’d Installation Rear PanelInputs Power Installation, cont’dRemote control Front PanelThree Front Panel OperationSaving or Recalling a Preset Front Panel OperationCreating a Tie Selecting Lock mode 2 or toggling between mode 2 and mode Control Release the Control buttonsViewing Ties and Muting Outputs Press and hold the Audio button until the Audio LED flashesPress and release the Audio button to exit Remote Control Optimizing the Video FourFront Panel Operation, cont’d Remote Control and Optimizing the Video Selected SIS CommandsHost-to-switcher instructions Command Ascii command Response Additional description Create tiesOutput pre-peaking Remote Control and Optimizing the Video, cont’dAudio/RS-232 TP input wire pair 3 and 6 configuration Local video output sync polarityAudio output volume Remote Control and Optimizing the Video, cont’dAudio or RS-232 mute commands Audio input gain and attenuationSave and recall presets Lock executive modesInformation requests Installing the program Starting the programClick the Software tab Optimizing the video

MTPX 1616, MTPX 816, MTPX 3216, MTPX 1632, MTPX 168 specifications

Extron Electronics is renowned for its commitment to high-quality audio-visual distribution solutions, and the MTPX Series is no exception. The MTPX Series features a range of versatile matrix switchers designed to accommodate various AV signal formats, including composite video, S-Video, and RGBHV. Among the models in this series, the MTPX 3232, MTPX 168, MTPX 1632, and MTPX 3216 stand out for their advanced technology and user-friendly features, making them ideal for many applications.

The MTPX 3232 offers robust capabilities with 32 inputs and 32 outputs, providing high flexibility for large installations where multiple source devices need to be routed to multiple displays. Each output can be individually controlled, allowing seamless switching between different sources with minimal delay. This model supports a range of video formats, ensuring compatibility with various equipment.

For smaller installations, the MTPX 168 and MTPX 1632 models present excellent alternatives. The MTPX 168 is designed with 16 inputs and 8 outputs, providing efficient routing for systems that require fewer connections. Meanwhile, the MTPX 1632 has 16 input and 32 output configurations, ensuring versatile signal routing for enhanced scalability. These models employ Extron's robust technology, such as the proprietary Extron XTP technology, which delivers high-performance signal distribution over long distances.

The MTPX 3216 model adds another dimension with its 32 input and 16 output setup, offering a balanced solution for various AV needs while maintaining excellent signal integrity. All models feature advanced video processing technologies that help eliminate flickering and ensure high-quality video performance even in demanding environments.

A significant feature across the MTPX Series is the built-in web interface, which simplifies the configuration, monitoring, and control of the matrix switchers. This user-friendly platform allows technicians to manage inputs and outputs remotely, ensuring seamless transitions during events and presentations. Furthermore, Extron's advanced EDID Management ensures optimal performance by allowing the switchers to communicate effectively with connected devices.

With exceptional build quality and user-centric features, the Extron MTPX Series stands out as a reliable choice for professional AV installation, enhancing the way audio and video signals are managed in various settings. Whether for a classroom, boardroom, or large venue, these models provide the versatility and performance needed to create impactful AV experiences.
Top Page Image Contents