Extron electronic user manual SCP 100P Specifications, Parts, Accessories, Dimensions

Page 11

Specifications, Parts, Accessories, Dimensions, cont’d

Template

Use the template as a guide to mark and cut the hole in the wall or furniture through which the SCP 100P will be installed. The template includes the recommended 0.1” (0.25 cm) clearance on all sides of the electrical wall box to allow room for the raised areas surrounding the knockouts. See chapter two for details on installing the SCP 100P.

The light gray area represents the layout of the electrical box (3.75"H x 3.75"W) against the rear of the SCP 100P front panel.

To install the control panel without a wall box, use the cut-out area (3.00"H) indicated by the dotted line.

The dashed line indicates the cut-out area (3.95"H x 3.95"W) for installing the electrical wall box.

A-4 SCP 100P • Specifications, Parts, Accessories, Dimensions

Page 10 Page 11
Image 11
Page 10 Page 11
Contents Control Panel User’s ManualPrecautions Table of Contents One Introduction and InstallationTable of Contents, cont’d SCP 100P Introduction and Installation Installation InstructionsPreparing the site, installing the wall box Mounting the SCP to the wall box Introduction and Installation, cont’dPre-installation testing/troubleshooting Rear panel circuit board and cablingOperation Application diagramTwo Operationration, cont’d Front Panel FeaturesSystem control features Audio adjustment control and LEDsInput selection buttons and LEDs Specifications, Parts, Accessories, and DimensionsAAppendix Operation, cont’dIncluded Parts SpecificationsAccessories Panel DimensionsSCP 100P Specifications, Parts, Accessories, Dimensions
Top Page Image Contents